Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
STEEL S13.4
Professional Power Amplifier
Steel S13.4 is a professional power amplifier with a
maximum output power of 4 x 1220W @ 8-ohm / 4
x 1670W @ 4-ohm and a maximum bridged output
power of 2 x 4000W (RMS) @ 8-ohm. With a per-
formance that stands out for its very low distortion
and high fidelity, Steel S13.4 is equipped with a
switching-mode power supply. Precisely thanks to
the design of its power supply, the amplifier allows
the peak power to follow the dynamic range of the
musical program, being able to reproduce up to
twice the RMS power, without clipping. This trans-
lates, basically, into peaks with much more dynam-
ic range than a conventional-source amplifier. As
one would expect in amplifiers of this range, the
whole Steel series is equipped with a very efficient
ventilation and has a comprehensive section of
protections, to assure its correct operation in the
most demanding situations.
Specifications
Output
•
Rated output power (8-Ohm): 4 x 1220W
•
Rated output power (4-Ohm): 4 x 1670W
•
Rated output power (Bridge @ 8-Ohm): 2 x
4000W
Performance
•
Input impedance:
•
Balanced: 20Kohm
•
Unbalanced: 10Kohm
•
Input sensitivity: 0.775Vor1.4V
•
Frequency Response: 20Hz~20KHz
•
THD: <0.05%
•
Damping factor (8-ohms) 10Hz-400Hz: >200
•
Crosstalk (at 1Khz): - 75dB
•
Signal to noise ratio: >100dB
•
Slew rate: 20V/us
•
Voltage gain: 37.8dB
P. 4
AUDIOLAB STEEL SERIES -
English version
•
Intermodulation distortion: =/<0.35%
•
Protections: Thermal, short circuits, no-load,
on/off muting & RF interference
Connectors & back panel controls
•
Power supply connector: Interlock In
•
4 XLR-3 inputs
•
4 Speakon speaker outputs
•
Bridge, parallel & input sensibility switch
Physical
•
Cooling: Two Front-to-back fans, tempera-
ture controlled speed.
•
Net Weight: 13 kg. / 28.6 lbs.
•
Dimensions: 482x349x88 mm. / 19x13.7x3.5
in.
Publicidad
Tabla de contenido
