Enabling Weighing Units; Restoring The Factory Default Setup; Communication With A Computer - SOLVO VALLÉS FH Serie Manual De Utilización

rate and press
5. Press the
6. Press the
indicates even check.
7. Choose the proper check type and press the
normal weighing mode.

ENABLING WEIGHING UNITS

The units function can be programmed to turn certain weighing units on or off. To enable or disable
certains units of measure, perfom the following procedure:
1. Press the
2. Press the
3. Press the
key to confirm. To disable g as the unit, press the
press the
4. Follow the steps above mentioned to enable or disable Oz, Ct or dwt as the unit of measure.

RESTORING THE FACTORY DEFAULT SETUP

1. Press the
2. Press the
3. Press the
Factory default setup is finished.

COMMUNICATION WITH A COMPUTER

The balance keyboard functions can be accessed via the RS-232 interface. The
following commands are available:
U – Unit: units conversion
T – Tare: tare function
C – CAL: calibration with external standard weight
P – PRINT: print function
% - %: percent function
# - #: instant print
M – COUNT: counting function
key to confirm. The balance reads "ParITy" and begins parity check.
key, the balance readss "nOnE" (no check) for the first-
key, it reads the other check types; "Odd" indicates odd check and "EvEn"
key while pressing the
key repeatedly until it reads "unIT"
key the display reads "g yes" which means g is available for use. Press the
key to confirm.
key while pressing the
key repeatedly until it reads "InITIA"
key to confirm, the display reads "BUSY" and the returns to weighing mode.
key to confirm, the balance now returns to
key, the display will show "PrInT"
key, the display will show "g no",
key the display will show "PrInT"