Skoda TRUNK GRILLE Manual De Instrucciones página 13

Trunk grille
The accessories are intended for professional fitting. ŠKODA AUTO recommends that they are
fitted by a contractual partner.
Please note: The trunk grille can only be fitted in ŠKODA KAROQ
vehicles with fixed rear seats.
Component index for the trunk grille set (fig. 1)
Component
Trunk grille
M8 bolt
M8 rivet nut
Cover cap (for fitting onto the C-pillar trim)
Adapter (for inserting into the opening in the body
underneath the C-pillar trim)
Cover cap (for fitting into the luggage compartment lining)
Adapter (for inserting into the opening in the body
underneath the luggage compartment lining)
Template (for marking where the hole is to be drilled
in the C-pillar trim)
Template (left and right – for marking where
the hole is to be drilled in the luggage compartment lining)
Fitting instructions
Note:
If the rivet nuts are ever lost, you can order more from the ŠKODA Original Accessories
catalogue using part number 5L6 071 754.
List of special tools
Hole saw bit (25 mm diameter) for drilling holes in the C-pillar trim and in the luggage com-
partment lining.
Riveting tool for riveting rivet nuts (C) (in the holes underneath the C-pillar trims and in the
holes underneath the luggage compartment lining)
- MTX 9-193/C (or MTX 9-193/A with MTX 9-295 reducer) –
order the tool from the Schenker range.
- 21 mm open-end wrench, no. 10 Allen key.
Tool for screwing in the adapters (E, G)
- M8 x 50 bolt, M8 nut with washer, 13 mm open-end wrench.
Pin, suction device.
Important fitting information
Remove the luggage compartment cover from the vehicle and fold the rear seat backs
forwards.
Quantity Item
1 A
4 B
4 C
2 D
2 E
2 F
2 G
1 H
2 J
1
EN
13