Use And Starting - ECCOTEMP L5 Manual De Uso Y Cuidad

Eccotemp Systems LLC | Email: Support@eccotemp.com | Address: 315 - A Industrial RD Summerville, SC 29483

Use and Starting

Warning: This model is intended for recreational & portable use only. This model
CANNOT be permanently mounted or plumbed in any way.
1. Turn on incoming water supply. Ensure that you have adequate water pressure
between 20-80 PSI.
2. Turn your water output device to its "off" position.
3. Turn the gas valve on the cylinder all the way open.
4. IF THE SMELL OF GAS IS DETECTED, TURN OFF THE GAS VALVE IMMEDIATELY!!
5. Set the water regulator knob on the face of the portable tankless water heater
to its highest setting.
6. Set the gas regulator knob on the face of the portable tankless water heater
to its minimum setting.
7. Turn on your water output device to the "on" position and adjust to the desired
water flow.
8. There will be a series of audible clicks and the burner will ignite. Should
the burner not ignite after 5 seconds, shut off and go to the "Trouble
Shooting" section.
9. Upon completion of use or storage, open the drain valve (ribbed cylindrical
stem next to the water input valve) to ensure draining of water.
10. Turn off your gas supply.
11. WARNING: If the outside temperature is around or below freezing (32 degrees
F, 0 degrees C), ensure that the drain valve is opened and water drained from
the portable tankless water heater after each use to avoid internal damage to the
water regulator. You will also need to unhook the outgoing water line to ensure
that any water in the heat exchanger is drained. Failure to properly drain your
portable tankless water heater will cause water damage which may or may not
be reparable. Please check the warranty information found on our website at
www.eccotemp.com/freeze for more information on freezing issues.
THE L5,L7,& L10 PORTABLE TANKLESS WATER HEATERS HAVE 1/2" TO 3/8" ADAPTER IN THE
THIS ADAPTER MUST BE INSTALLED WITH THREAD SEALANT, A SPOOL OF SEALANT TAPE IS INCLUDED
MULTIPLE WRAPS OF SEALANT TAPE MAY BE NECESSARY TO ASSURE COMPLETE SEAL.
PLEASE NOTE: THIS MODEL IS NOT RECOMMENDED NOR HAS IT BEEN TESTED FOR ANY PERMANENT INSTALLATIONS. THIS MODEL IS PART OF OUR
PORTABLE SERIES AND NEEDS TO BE TAKEN DOWN AND STORED IN A WARM DRY PLACE AFTER EVERY USE.
THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE.
Product Support: Eccotemp.com/help-desk
WARNING!
GAS HOSE ADAPTER
HARDWARE PACK FOR ATTACHMENT OF THE LP HOSE TO THE HEATER.
WITH THE HEATER.
ALWAYS CHECK FOR GAS LEAKS BEFORE USING HEATER.
Shop Online: Eccotemp.com/products Store Locator: Eccotemp.com/locator
7