Normal Operation - Vimar Elvox ECRU Manual Para El Conexionado Y El Uso

REMOTE
LEARNING POSITION

4- NORMAL OPERATION

When switching on, the receiver produces a flash lasting approximately 1 second of the four LEDS DL1...DL4. The colour of the
LEDS indicates the type of remote control (rolling code or fixed code) currently managed by the receiver:
Colour Remote control type
Orange Rolling Code
Green Fixed code
No codes stored:
Red the first learned remote control (see points 5 to 8) will determine the type of remote controls managed by the receiver.
Only completely deleting the learned remote controls (see point 10) will allow you to change the type.
At the end of this alert the receiver is in its normal operating state, where as a result of receiving a saved remote control the output
of the channel associated with it is activated, in agreement with the type of output:
Type Operation
Monostable Each pulse of the remote control activates the associated output for 1 sec
Bistable Each pulse of the remote control activates / deactivates the associated output
Timed Each pulse of the remote control activates the output for a time set by trimmer TR1 (see point 13)
The activation of an output is also signalled by the corresponding LED coming on DL1 ... DL4. The reception of a remote control
is signalled by the flashing of the blue LED DL5. The LED also flashes when receiving a remote control that is not stored in the
receiver.
8
Power supply
Aerial
EN