Important - EMU SHADE 981 Manual Del Usario

EMU SHADE UMBRELLA ART.981
IMPORTANT: Please read this entire manual before installing or operating your EMU Shade Umbrella.
Upon receipt of your SHADE art.981, please check to ensure you have received all the components. If anything is
missing or damaged, contact your seller.
SHADE UMBRELLA WIND RESISTANCE GUIDELINES: Light to Moderate Winds
When installed properly, the Shade Umbrella is engineered to handle light to moderate wind conditions in the open
canopy position. Please adhere to these common sense wind guidelines:
1. Do not keep the Shade Umbrella in a tilt position if you are experiencing windy conditions.
2. As winds get stronger or in anticipation of uncertain/severe weather conditions, the canopy should be
lowered to the folded position and strapped to the mast.
3. The Shade Umbrella should always be left in the folded and strapped position when unattended or not in use.
4. In anticipation of and during extremely severe weather conditions, it is advisable to remove and store
the entire Shade Umbrella structure to protect it from storm-related debris.
DIAGRAM & LEGEND:
6
5
3
4
2
1
7
1. Base
2. Mast
3. Crank
4. Locator pin
5. Slider car stop pin
6. Slider car
7. Turning handle
6
5
3
4
4
7
COMPONENTS, FITTINGS & HARDWARE
A. MAST: The SHADE MAST (2) must be assembled to the base by n.5 screws. The plate of the MAST (2) is 145 mm in
diameter and 12 mm thick and it has 5 holes where to insert 5 bolts.
B. BOLTS: Five (5) countersunk BOLTS are used to bolt the MAST (2) to the BASE (1). BOLTS are 20mm in length.
[M10X20].
C. LOCATOR PIN: When the LOCATOR PIN (4) is inserted through the MAST (2), it locks the MAST (2) into place. The
TURNING HANDLE (7) is located below the LOCATOR PIN (4). When the LOCATOR PIN (4) is pulled out, the
TURNING HANDLE (7) can be lifted to rotate the MAST (2) to one of 12 holes, allowing the SHADE to rotate 360
degrees around the mast.
D. CRANK: The CRANK (3) facilitates the opening and closing of the SHADE canopy structure. It must be assembled to
the MAST by a screw and hexagonal key.
E. SPACER BUTTONS: Eight (8) SPACER BUTTONS are inserted into predrilled holes on the arms. SPACER
BUTTONS must be left inserted at all times as they ensure the SHADE canopy structure opens easily by not allowing the
arms to get locked down.
F. CAP: This CAP saves the fabric cover top from injures due to the movement.
G. BASE FRAME: The 1174X520 mm base frame is in e-coated steel, and it is the housing of n.4 BALLASTS.
H. BASE COVER: 1180X525 mm metal sheet cover.
I. BALLAST (optional): It is 500X500X50 mm ballast of weight 25 kg.
A. MAST
E. SPACER BUTTONS
1
B. BOLT
C. LOCATOR PIN
F. CAP G. BASE FRAME
D. CRANK
H. BASE COVER
2