HI-Q TOOLS PM750 Manual De Instrucciones página 9

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

is a positive ground system (very uncommon), follow the
below instructions in reverse order.
1.) Connect the positive (orange) battery clamp or eye-
let terminal connector to the positive (POS,P,+) battery
terminal.
2.) Connect the negative (black) battery clamp or eyelet
terminal connector to the negative (NEG,N,-) battery ter-
minal or vehicle chassis.
3.) Connect the battery charger's AC power plug into a
suitable electrical outlet. Do not face the battery when
making this connection.
4.) When disconnecting the battery charger, disconnect
in the reverse sequence, removing the negative first
(or positive first for positive ground systems).
BEGIN CHARGING
1.) Verify the voltage and chemistry of the battery.
2.) Confirm that you have connected the battery clamps
or eyelet terminal connectors properly and the AC power
plug is plugged into an electrical outlet.
3.) The charger will begin in Standby mode, indicated by
an orange LED. In Standby, the charger is not providing
any power.
4.) Press the mode button to toggle to the appropriate
charge mode (press and hold for three seconds to enter
an advanced charge mode) for the voltage and chemis-
try of your battery.
5.) The mode LED will illuminate the selected charge
mode and the Charge LEDs will illuminate (depending on
the health of the battery) indicating the charging process
has started.
6.) The charger can now be left connected to the battery
at all times to provide maintenance charging.
UNDERSTANDING CHARGE LEDS
The charger has one Charge LED. This Charge LED in-
dicates the connected battery(s) state-of-charge (SOC).
See the explanation below:
LED
The Charge LED will slowly pulse "on"
Pulsing
and "off" when the battery is less than
Red LED
75% fully charged.
The Charge LED will slowly pulse "on"
Pulsing
and "off" when the battery is less than
Green LED
90% charged.
Pulsing
When the battery is 100% charged, the
Charge LED will be solid green.
Green LED
During maintenance charging, the 100%
Charge LED will pulse "on" and "off"
Mainte-
slowly. When the battery is topped
nance
off and fully charged again, the 100%
Green LED
Charge LED will turn solid green. The
charger can be left connected to the
battery indefinitely.
Explanation
17

Publicidad

Tabla de contenido
loading

Productos relacionados para HI-Q TOOLS PM750

Tabla de contenido