About Staples & Nails - Arrow T50R.E.D. Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

HOW TO DETERMINE PROPER STAPLE LEG SIZE
In choosing the proper staple leg length for a job there are two basic things
to consider:
1. Thickness of material to be stapled.
2. Hardness of the wood.
As a general rule, in hardwood, approximately 3/16" to 1/4" penetration
into the wood is sufficient...and for softwood – up to approximately 3/8"
should be sufficient. However, if the staple used "stands away" from the
work – this means that too long a leg length has been used. In that case
we recommend the next shorter leg length for desired results.
STAPLE PENETRATION
The T50R.E.D.™ has a hi/low power setting to help drive staples and brad nails into hard and soft materials. For best penetration press
down on the front end with the palm of your hand to prevent recoil when operating.
NAIL PENETRATION
The T50R.E.D.™ shoots a 5/8" (15mm), 3/4" (20mm) and 1" (25mm) brad nails. For best penetration, hold the gun flat against the surface.
Do not tilt or raise the gun.
A WORD ABOUT ARROW
®
STAPLES & NAILS
Only Arrow
®
knows the proper staple and nail tolerances required for best performance of the T50R.E.D.™ Staple + Nail Gun. Only Genuine
Arrow
®
T50
®
staples and Arrow
®
nails are made to these exact tolerances to insure top fastening performance. Accept no substitutes. Always
insist on Genuine Arrow
®
Staples and Nails.
ABOUT STAPLES AND NAILS
BACK TO
INDEX
4

Publicidad

Tabla de contenido
loading

Tabla de contenido