Pump Specifications And Parts List - Liberty Pumps LowPro41LP Manual De Instalación

Finish Flooring (Tile, Linoleum etc.)
Sub-flooring (Plywood etc.)

4. Pump Specifications and Parts List

Item Part No.
1 4622000
2 LE41LP
3 4623000
4 462100B
5 4616000
6 462000B
7 8131000
8 8129000
9 4022000
10 4624000
11 8018000
12 4039000
13 4039RA0
14 CV200C
15 4762000
16 4627000
17 4626000
18 4625000
Refer to the diagram
to adjust the float
switch (5). The
pump should engage
at a waste depth of
approximately 4.0"
and pump down to
around 3.0". To
adjust the float
switch, remove the
switch access cover
(6) and lift the float
switch (5) out of the
tank. After adjusting
to the lengths
pictured above,
replace the switch by
placing the cord
between the two
bosses. Reattach
the access cover to
the tank.
Spacer (one each of 1/4" and 1/2" provided.
May be stacked for total of 3/4")
Description
Tank, low profile
Pump, 4/10Hp sewage, 115V
Nipple, 2" PVC Sched. 80
Cover, pump access
Switch, vertical master
Cover, switch access
Washer, flat 1/4" X 3/4" S.S.
Bolt, 1/4"-20 X 5/8", Hex head S.S.
Stopper, double cord hole
Closet Flange, brass
Screw, 1/4"-20 X 5/8" slotted Flt. Hd.
Gasket, cover 1" X 1/8" tape
Gasket Tape, for closet flange
Check Valve, 2" PVC compression fit
Grommet, Pipe seal, 2"
Wax Ring
Closet flange extension kit
Closet bolt kit
1
©Copyright 2009 Liberty Pumps Inc. All rights reserved
Pump Specifications LOWPRO41LP
Hp
Qty.
Volts
Phase
Full Load Amps
1
Hz
1
Solids-handling
1
Discharge size
1
1
1
14
14
NOTE: The LowPro has a shut-off head
1
(maximum lift) of 19 feet. Actual maximum
1
useable head to provide adequate flow is
4
approximately 17.5 feet and may be less
1
depending on amount of run and friction loss
1
factors.
1
pump sizing.
1
1
1
Fig. 6
4/10
115
1
12
60
2"
2"
Please consult factory for proper
5