Storage And Transport - Gorenje TC 200 Serie Instrucciones De Uso

Dear buyer, thank you for purchasing our product.
PRIOR TO THE INSTALLATION AND FIRST USE OF THE HOT WATER STORAGE
TANK WITH THE HEAT PUMP, PLEASE READ THESE INSTRUCTIONS CAREFULLY.
This storage tank has been manufactured in compliance with the relevant Standards, which allow the manufacturer the use of the
CE sign. The technical characteristics of the product are listed on the label attached to the protective cover.
The connection of the storage tank with the heat pump to the plumbing and power networks must be carried out by qualified staff
only. All repairs and maintenance work in the interior of the storage tank, as well as limestone removal or testing or replacement
of the corrosion protection anode, may only be carried out by an approved maintenance service provider. Be especially careful
when following instructions for potential errors and safe use of the heat pump.
Store this booklet for times of doubt upon the functioning or maintenance.
The installation manual is available on our webpage http://www.gorenje.com or the webpages per country in the service and
support section.
Authorised maintenance personnel are available for occasional maintenance. They will help you with their vast experience.
The hot water storage tank is designed in a manner which allows using the following heating sources:
• Central heating storage,
• Solar power,
• Electric heater.
USE
This unit is designed for production of sanitary water in households and at premises where daily consumption of hot water (50
°C) does not exceed 400 l to 700 l. The set temperature should suffice actual needs. Recommended temperature settings are
between 45 and 55 °C. Higher temperatures are not recommended as they reduce the efficiency (COP) and extend the time
of heating or increase the number of operating hours. Because during its operation the heat pump cools its surroundings, the
usefulness of the heat pump is doubled (heating water – cooling air). The operation of the heat pump is completely automatic.
The appliance must be connected to water supply mains and to the power supply grid. The air intake and air exhaust may also be
provided by designing the inlet and outlet drain from and to the adjacent room. We recommend leaving enough space between
the floor and unit as to provide easy access to the Mg anode (for maintenance or replacement purposes – Fig. 2). The heat pump
may not be used for purposes other than those defined in these Instructions. The unit is not designed for industrial use or use in
rooms where corrosive or explosive substances are present.
The manufacturer shall not assume any liability for damages caused by incorrect installation or misuse that are not in compliance
with the Instructions for installation and use.
The instructions for use are a component and important part of this product and must be delivered to the customer. Read the
warnings carefully, as they contain important directions related to safety during operation, use and maintenance.
Keep these Instructions for later use.
The marking of the heat pump is stated on the nameplate located on the bottom side of the unit, between both inlet pipes for
sanitary water.
Once the packaging is removed, check the contents. When in doubt, contact your dealer. Never let children play with the
packaging parts (clamping, plastic bags, expanded polystyrol, etc.) – potential risk. Make sure to remove and dispose of the
packaging safely and in an environmentally friendly way.
The appliance is not intended for use in closed space, containing corrosive and explosive materials.
In time of transport, the heat pump must be placed in the upright position and can be leant up to 35° in all directions
upon exception. Please make sure, no damage of the casing and other vital parts of the appliance occurs during
transport.

STORAGE AND TRANSPORT

Store the heat pump in an upright position, in a clean and dry place.
21