Rear-Facinginstallation With Latch - Graco Contender 65 El Manual Del Propietario

REAR-FACING INSTALLATION WITH
1. Recline flip foot must be in
REAR-FACING position (a). (If it is
not, see page 36, Recline Flip Foot.)
2. LATCH belt must be routed through
the opening in child restraint marked
as REAR-FACING with a BLUE label
(b). (If it is not, see page 40,
Belt Routing For Rear-Facing Mode.)
3. Place rear-facing
equipped with
ease of installation, extend
belt to its maximum length.
4. Attach LATCH
vehicle lower anchors (c). Belt must
lie flat and not be twisted. Pull
connectors to be sure they are
securely attached to the anchor
points. (d).
5. Press down firmly in center of child
restraint while pulling on the tail of
the LATCH belt to tighten (e).
LATCH
on vehicle seat
LATCH anchors. For
LATCH
connectors to
a
CLICK!
c
e
20
LATCH
b
d