Graco Contender 65 El Manual Del Propietario página 23

6. Press down firmly in center of child restraint to compress
vehicle seat cushion while pulling on the tail of the
belt to tighten (e).
7. Hold seat and pull front to back and left to right at belt path
to check for secure installation (f). The child restraint should
not move side to side or forward more than 1 inch (2.5 cm).
8. Check that the lower anchor belt stays tight and does not
slip from the tightened position. If it does not stay tight,
try another seating position or contact Customer Service.
9. Attach tether strap hook (A) to anchor hardware (B) and
tighten adjustment belt to remove any slack (g). Belt
must lie flat and not be twisted. Periodically check that
child restraint is securely installed; adjust if necessary.
• NOTE: Some vehicle manufacturers have lower maximum
weight ratings for
your vehicle owner's manual or call the vehicle manufacturer
to confirm the limits on your vehicle's
• To remove LATCH, see "Removing
Anchor Points", p. 38.
LATCH
anchors, so you must consult
LATCH
LATCH anchors.
LATCH
from Vehicle
23
A
B
Pull to
Tighten
g
Tether
LATCH
Do not install by this
method for a child
weighing more than
45 lb (20 kg).