Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Tuner
Listening to the radio
1
2
These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on page 16.
This unit's AF (alternative frequencies search)
function can be switched on and off. AF should
be off for normal tuning operation (refer to page
19).
1
indicator
BAND
Shows which band the radio is tuned to, MW,
LW or FM.
2
(
) indicator
STEREO
ST
Shows that the frequency selected is being
broadcast in stereo.
3
indicator
FREQUENCY
Shows to which frequency the tuner is
tuned.
4
indicator
PRESET NUMBER
Shows what preset has been selected.
1 Press
to select the tuner
SOURCE
Press
until you see
SOURCE
2 Use
to adjust the sound level.
VOLUME
Rotate to increase or decrease the volume.
3 Press
to select a band
BAND
Press
until the desired band is displayed,
BAND
,
,
for FM or
FM1
FM2
FM3
4
3
.
displayed.
Tuner
.
.
MW/LW
4 To perform manual tuning, press 2 or 3
with quick presses.
The frequencies move up or down step by step.
5 To perform seek tuning, press and hold 2
or 3 for about one second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
• You can cancel seek tuning by pressing either
2 or 3 with a quick press.
• If you press and hold 2 or 3 you can skip
broadcasting stations. Seek tuning starts as
soon as you release the buttons.
Note
• When the frequency selected is being broad-
cast in stereo the
STEREO (ST)
light.
Section
03
indicator will
En
15
Publicidad
Capítulos
Tabla de contenido
