Initial Settings; Adjusting Initial Settings; Setting The Time; Setting The Fm Tuning Step - Pioneer DEH-P8400MP Manual De Operación

Initial Settings

Adjusting initial settings

1
Initial settings lets you perform initial set up of
different settings for this unit.
1
display
FUNCTION
Shows the function status.
1 Press and hold until the unit turns
SOURCE
off.
2 Press to open the front panel.
OPEN
3 Press and hold until
FUNCTION
appears in the display.
4 Press to select one of the initial
FUNCTION
settings.
Press repeatedly to switch between
FUNCTION
the following settings:
— — —
CLOCK FM DAB A-PI
— — —
AUX DIM BRIGHT
—
TEL2 DISP
Use the following instructions to operate each
particular setting.
• To cancel initial settings, press
• You can also cancel initial settings by holding
down until the unit turns off.
FUNCTION
CLOCK
— — —
WARN D OPEN
— — —
ILL SW TEL1
.
BAND

Setting the time

This is used to set the time on the unit's clock
display.
1 Press to open the front panel.
OPEN
2 Press to select
FUNCTION
Press until the time appears in the
FUNCTION
display.
3 Select the portion of the time display you
wish to set with 2/3.
Pressing 2/3 will select a portion of the clock
display:
—
HOUR MINUTE
As you select portions of the clock display the
portion selected will blink.
4 Select the correct time with 5/∞.
Pressing 5 will increase the selected hour or
minute. Pressing ∞ will decrease the selected
hour or minute.

Setting the FM tuning step

Normally the FM tuning step employed by seek
tuning is 50 kHz. When AF or TA is on the tuning
step automatically changes to 100 kHz. It may
be preferable to set the tuning step to 50 kHz
when AF is on.
1 Press to open the front panel.
OPEN
Section
09
.
CLOCK
En 49