Cleaning And Pollution Precautions; Installation Manual; Installation Manual - Mechanical Installation; General Information - OmarLift C40 Manual De Instrucciones

Operating instructions for
MINILIFT PUMP UNIT C40 - C50
This Instruction Manual applies to the entire life of
the system/product from installation, during normal
operation; from the tests until maintenance; it is an
integral part of the system and must be kept in a
protected and accessible place by the installation
technician.
Before starting installation work:
Access to the site, installation, commissioning and
maintenance of the system must be performed only
by expert personnel.
- Install safety devices to protect personnel and
prevent them falling (for example platform or
harnesses)
- Cover (safely)any open fl oor or walls
- Use safe installation tools and objects that
prevent accidental falls
- Open stroke chambers must be closed and
warning notices must be prominently displayed
when working in open areas.
Work involving electrical equipment must be
carried out by an electrician or qualifi ed person.

2.5 Cleaning and pollution precautions

Impurities and dirt inside the hydraulic system cause
faults and wear.
All parts of the system that are dismantled for
controls or repair, as also the pipes and fi ttings, must
be completely clean before they are refi tted.
Any oil leaks from the circuit during repair operations
must not leak into the environment but must be
immediately cleaned up with rags or sponges.
The manufacturer reserves the right to make changes without prior notice!
3

Installation manual

3.1. Installation manual – Mechanical
installation

3.1.1. General information

Before starting installation, it is in your
interest to check the structural and
spatial limits within which you will have to work.
Consider where (workshop or elsewhere) and when
the assembly methods have to be applied. All the
relevant conditions must therefore be considered in
advance that relate to the various work procedures
and no action should be taken without fi rst
considering the consequences. Check that the goods
received contain everything requested and that all
the products and individual parts are as prescribed
and have not been damaged during transit.
The information on the rating plate must be
compared with the order form.
During the period of storage, keep the
material in its original package, protected
from bad weather and direct exposure to the sun in
order to avoid accumulations of water/condensation
that could occur inside the packaging. (See technical
data on temperature and humidity limits). Never
dump packaging material in the environment.
Once the product has been dismantled, it must be
disposed of correctly in compliance with local laws;
do not dump in the environment. Before recycling,
check the nature of the various materials and recycle
in the prescribed manner.
OMARLIFT accepts no liability for harm
arising from tampering with (or changes to)
the packaging material by third parties.
Page: D846M5L.004
Date of Issue: 14/03/2012
Version: Rev. 02
Approved: UT