Rear Panel; Remote Control - Marq FOG400LED Guia Del Usuario

Features

Rear Panel

1. Cap: Twist this
counterclockwise to loosen it. The tube that passes
through its center feeds the fluid in the tank to the heater.
2. Fluid Level Indicator: This transparent part of the tank
shows its current level of fluid. If this approaches the Low
reading, fill the tank with the recommended water-based
fog fluid.
3. Power Cord: Connect this attached power cord to a
power outlet.
4. Fuse: If the fuse is broken, disconnect the power cord
from the power outlet, and then unscrew this holder to
replace the fuse. Replace it with a fuse with an appropriate
rating (printed under on the rear panel). Using a fuse with
an incorrect rating can damage the product and/or fuse.
5. Power Switch: Use this switch to power Fog 400 LED on
or off. After powering it on, wait for 2–3 minutes until the
heater is warmed up and the Ready light on the remote
control illuminates.
6. Remote Control Input: Connect the remote control to this
input.

Remote Control

1. Fog Switch: Use this switch to start or stop the production
of fog.
2. Ready Light: This light will illuminate when Fog 400 LED is
warmed up and ready to use.
4
cap clockwise to tighten it or
6
5
1
2
4
3
2
1