Juiceman JM8000S Manual Del Usuario página 6

DISASSEMBLING THE JUICE EXTRACTOR
1. Pull up at the bottom of each locking latch to disengage from the tab on the cover.
The locking latches will raise up, so you can release them from the lid.
2. To remove the lid, take out the food pusher, grasp the feed chute and pull up.
3. To remove the integrated pulp container, grip the side edges with one hand and the
back edge of the pulp container with the other. Pull up with the stainless steel
filter in place.
4. To remove the stainless steel filter, grasp the filter by the rim to pull it out.
Caution: The stainless steel filter cutting teeth are very sharp.
Handle it carefully.
5. Turn the pulp container upside-down.
6. Remove spout by grasping the center of the spout and pulling up
to release from the 4 latches. (see A)
ASSEMBLING THE JUICE EXTRACTOR
1. Turn the pulp container upside-down.
2. Insert removable spout onto pulp container by aligning the 4
latches and pushing down on the center until it
snaps into place (see B.)
3. Place integrated pulp container on the base with the juice
spout facing you.
4. Insert the stainless steel filter in the center of the integrated pulp
container and press down until it snaps into place.
5. Place the lid on top of the integrated pulp container.
6. Lock the locking latches by holding down the cover as you fit the locking mechanism
at the top of each latch over the tab on each side of the lid. Press the bottom of each
latch until you hear it click into place.
7. Insert the desired food pusher into the feed chute (see USING THE SMALL AND
LARGE FOOD PUSHERS). Place the food pusher into the feed chute, matching the
indentations on the food pusher to the projections on the feed chute.
Important: The appliance will not operate until the locking latches are locked.
USING THE ANIT-DRIP SPOUT
The Open/Close latch should be in the Closed ( ) position before and after each juicing
cycle to avoid dripping. The latch should be in the Open (
See CARE AND CLEANING for further instruction.
USING YOUR JUICE EXTRACTOR
Note: To begin, assemble the fruits and or vegetables to be used on the counter or in a
bowl next to the extractor, following the tips in PREPARATION.
Important: The integrated pulp container holds about 3½ cups of pulp. Do not allow
the integrated pulp container to overfill. This may cause the appliance to stall.
1. Plug appliance into a standard electrical outlet. Press the speed control switch to
the low setting (1) and allow it to run 10 seconds before placing any food into the
feed chute.
2. Place food in the feed chute and press lightly with food pusher.
3. Use the food pusher as a guide to gently direct the produce through the feed chute.
6
) position during juicing.
A.
B.