Care And Cleaning - Juiceman JM8000S Manual Del Usuario

3. Cut citrus fruit in half.
4. Place the cut-side of the fruit on top of the selected cone.
5. Press the speed control switch to low (1).
6. Using firm-to-moderate pressure, press down on the fruit to start the
juicing action
7. When done juicing, press the speed control switch to off (0) to stop rotation of juicer and
remove the fruit from the cone.
8. Flip the latch into the closed position.
9. Unplug the cord from the outlet.
CITRUS JUICER TIPS
• Before juicing a citrus fruit, roll the fruit under your hands on the countertop
exerting slight pressure. This helps to release the juice.
• Drop rind into disposal in your sink to clear out lingering odors from other foods.
• Add the zest of a lemon, lime or orange to simple syrup to add a fresh taste to iced
or hot teas
• Process 1 cup sugar with the zest of 1 lime or lemon and store in closed container in
your refrigerator. Use to decorate cookies, muffins and doughnuts.

Care and Cleaning

This product contains no user serviceable parts. Refer service to qualified service
personnel.
Important: Always unplug your juice extractor from the outlet before cleaning.
CLEANING
1. Disassemble the appliance following the instructions for disassembly.
Tip: Pulp from integrated pulp container can be used in many different ways: making
breads, muffins, cakes, soup stocks, compressed facial packs and garden compost
material. See USES FOR THE PULP.
2. Using a sponge or damp cloth, clean the base, feet and underside of the appliance.
If necessary, you may use a damp toothbrush or cloth to clean juice from the inside
the motor shaft (on top of motor base).
Important: Do not immerse the base in water or spray with water. Clean only by
wiping with a damp sponge, cloth or paper towel.
3. All parts – except the base – are dishwasher-safe (top-rack only) or you may wash
in warm, soapy water, using any mild liquid dishwashing detergent. Do not use any
products containing ammonia or scouring powders, as these can dull, scratch or
mar the surface. Use the cleaning brush provided to remove pulp left on any of the
removable parts. Do not use metal brushes or pads.
NOTE: If needed the Open/Close latch can be removed for cleaning.
Remove the Open/Close latch while in the open (
the pulp container upside-down. Locate the back of the latch where
it connects with the pulp container. Then press in the tab at the back
of the latch (see arrow) while pulling up. (see E)
4. To clean the food pusher properly, twist to unlock and remove the
small food pusher from the large food pusher. Clean with other
removable parts; once parts are dry, put back together.
5. To clean the filter, use cleaning brush provided to make sure tiny holes in mesh
) position. Turn
E.
9