Energy Saving Tips - Ariston MTA 4511 V Instalación Y Uso

Ice box
This unique ice box is an innovation of Merloni. By being
placed at the door inner liner in the freezer compartment, it
provides cleanliness and a higher ergonomics. Ice boxes are
no longer in touch with the other foods in the freezer
compartment. In addition, there is no risk of spilling or
springing of water during the placement of the ice box
(there is a plug to seal the filling hole subsequent to the
filling process.)
To remove the ice boxes,
hold and push it through the
upper ends and remove (Fig.
6). To replace align to the
upper ends and move it
down as it comes to a
vertical position to its place.
Usage
( Fig. 7)
Fill the ice boxes via the filling holes until reaching to the
shown level (MAX WATER LEVEL) and beware of overfilling.
Overfilling may cause and icing at the edges of the ice box
which may create difficulties to remove the ice cubes from
the ice box. In case of overfilling wait the ice to be melted,
empty the boxes and refill with it comply with the required
level. After filling the ice boxes via filling holes turn the case
0.
in 90 According to the compound boxes principle, the

Energy Saving Tips

- Install the Appliance Correctly
This means that the appliance should be installed away
from heat sources or direct sunlight in a well ventilated
room.
- Correct Temperature Settings
Set the refrigerator temperature knob to one of the
middle settings. Very cold temperature settings will not
only consume a great deal of energy but will neither
improve nor lengthen the storage life of the food.
Excessively cold temperatures may ruin vegetables, cold
cuts and cheese.
- Do Not Overfill Your Appliance
Remember that proper storage of food requires good air
circulation. Overfilling your appliance will hamper
proper air circulation and overwork the compressor.
- Keep the Door Closed
Open the refrigerator only when necessary; remember
Fig. 6
water will be at the identical level. Then, insert the plug and
replace the ice box. After the icing occurs, you can remove
the ice cubes from the filling holes by hitting the ice box to a
hard surface.
CAUTION: As filling the ice box, ensure that the box is empty
and there are no more ice residues left inside of it. The
optimum icing time is approximately 8 hours.
Fig. 7
that every time you open the door most of the cold air
will be lost. To bring the temperature back to the proper
level, the motor must run for a considerable amount of
time, consuming a substantial amount of energy.
- Check the Seal on the Door
Keep the seal clean and soft so that it fits tightly against
the door to ensure that no cold air is lost.
- Never Put Food in the Refrigerator while
Still Hot
A container of hot food in the refrigerator will increase
the temperature significantly; allow food to cool to
room temperature before storing.
- Check your appliance for build up of ice
Remember to check the walls of the freezer for ice; when
the layer becomes too thick, defrost the freezer
immediately (See "Maintenance instructions").
32