Instructions For Installation; Installation; Provisions Of The Law, Technical Rules And Regulations; Electrical Connection - Lotus CW - 4ET Instrucciones Para La Instalación Y El Uso

The data plate is attached to the rear panel (see drawing under "electrical connection") and contains all the
information necessary for the connection.
When positioning the appliance make sure that it is perfectly level. Small adjustments can be made by screwing
or unscrewing the adjustable small feet. The main switch or the socket must be in the vicinity of the appliance
and easily accessible. It is recommended to place the appliance under an extraction hood in order to rapidly
eliminate vapour. If the appliance is placed near walls or partitions, kitchen furniture, decorative coverings, etc.
these must be flameproof or coated with flameproof material. Above all, local fire prevention regulations must
be observed.
Attention: this appliance has been constructed in order to function in a unit. Whenever one plans to use it alone
it is necessary to have a distance of at least 10 cm.
The installation must be carried out in accordance with the following standards:
- The accident prevention and electrical legislation in force.
- Fire Department Regulations.
The installation, start-up and maintenance of this appliance must be carried out only by qualified personnel. All
the installation operations must be in accordance with the standards in force.
The manufacturer declines all responsibility for poor functioning due to incorrect installation or non-observance
of the regulations.
Warning: International provisions require that during the connection of the appliance there be a device which
allows the bi-polar disconnecting of the appliance from the network, upstream from the appliance. This device
must have a contact opening of at least 3 mm.
The appliance is supplied with
- turn off the power.
- remove the rear panel
- pass the new connection cable throught the cable clip, connect the wires in the corresponding terminal of the
terminal board and fix them
- lock the cable with the cable clip and reassemble the rear panel. The earth wire must be longer that the others
so in case the cable clip breaks, this disconnects after the tension cables
N.B. The connection cable must have the following characteristics: it must be at least of the H05 RN F type
and have a section suitable for the appliance power (see technical specification table)

INSTRUCTIONS FOR INSTALLATION

INSTALLATION

Provisions of the law,
technical rules and regulations
Installation

ELECTRICAL CONNECTION

the connection cable. If it has to be replaced proceed in the following manner:
CW - 4ET
CW - 6ET
41