Substituting The Nozzle In The Pilot Burner; Important; Checking Functioning; Maintenance - Lotus CW-94G Guia Para La Intalación E Instrucciones De Uso

• Using a suitable spanner, unscrew the nozzle and substitute it with the right one (see the technical data table).

SUBSTITUTING THE NOZZLE IN THE PILOT BURNER

The flame of the pilot burner has fixed air.
The only operation necessary is the substitution of the nozzle according to the type of gas.
It is therefore necessary to unscrew the screws as specified in the previous point; with a suitable spanner unscrew the
fitting and substitute the nozzle with a suitable one. With the right nozzle, the flame must lap the thermocouple.

Important!

After having carried out the conversion to another type of gas, it is necessary to update the data plate, indicating the
type of gas for which the appliance has been converted.
• The appliance contains the instructions necessary for use.
• Check the appliances for gas leaks.
• Examine the flame of the pilot burner; it must lap the thermocouple and be blue, otherwise examine the nozzle of
the pilot burner.
• Check the lighting and flame of the main burner.
• We urge the user to follow the instructions when using the appliance.
With prolonged use of the appliance, it is essential to carry out regular maintenance for the safe functioning of the
appliance; we therefore recommend drawing up a contract for after sales service.
Maintenance must be done only by specialized personnel, observing the norms in force and our indications.
It is possible to substitute parts such as: gas cock, piezoelectric device or gas piping in a very simple way. To substitute
the parts, proceed as follows:
• Cock: after taking off the front panel, unscrew the screwed fittings from the gas connections and the thermocouple
fitting, after which, substitute the cock.
• To substitute the thermocouple, unscrew the fitting of the pilot burner, likewise unscrew the thermocouple fitting
and substitute the element.
• The spark plug must be unscrewed and substituted.
Attention! In the event that smoke is given off when the appliance is started up, it is necessary to leave the appliance on
without being used for approximately an hour or until the smell disappears.

LIGHTING AND ADJUSTING THE MAIN BURNER

On the front panel, above each knob, the burner it corresponds to is indicated by the index
To light, turn the knob to the left from position "0" to the
keep it pushed down and press the button with the
Keep the knob pressed a few second and then let it go, this lights the pilot.
If the flame goes out you have to repeat the procedure.
By turning the knob round to the
By turning the knob round to the

Turning off the appliance

Push and turn the knob into position "0". This command blocks the gas supply to both the main burner and the pilot
burner. To relight the appliance, it is necessary to turn the knob again into position * and press the button.
GB

CHECKING FUNCTIONING

MAINTENANCE

SPARE PARTS

INSTRUCTIONS FOR USE

To switch off, move the knob back into position " 0".
IE
IT CH
symbol until the gas lights
position the burner is at maximum
position the burner is at minimum.
27
symbol (see figure);