Packing List - SPX OTC 1794 Lista De Piezas E Instrucciones De Funcionamiento

Parts List & Operating Instructions
Parts
Cylinder Assembly
Legs
Bolts
Swivel/Casters
Handle
Saddle Assembly
Corner Support Bracket
Chain Pack
1. Assemble the swivel casters on the jack legs using spring
washers and nuts provided.
2. Assemble the legs (with casters) to the jack's base, and slightly
secure with the 1/2" Allen socket bolts and spring washers
provided.
3. Position the jack (with legs) on a hard level surface. Tighten the
1/2" Allen socket bolts while all four casters are contacting the
floor, and the jack appears vertical to the floor.
4. Assemble the handle by screwing it into the handle socket on the
top base and tightening it with your hand.
5. Saddle assembly: Loosen the screw from outside the saddle
adapter. Mount the saddle adapter onto the top of the piston rod.
Once mounted, tighten the screw and secure the entire saddle
assembly.
6. Use the tilt adjusting knob to adjust the saddle angle to a relatively
horizontal position.
7. Attach the two corner support brackets onto the saddle board, and
fasten with the 1/2" hex bolts and nuts.
8. Locate the corner support bracket in the chain pack. Assemble
the corner support bracket on the saddle side frame, and secure
with the nuts mounted. Assemble chains and chain hardware to
the corner support bracket.
9. Chains and chain hardware are provided to secure a transmission, transfer box, or differential to the saddle
assembly according to the different shape of each housing. When in use, both ends of the chain should be
anchored to the bracket.
WARNING: DO NOT RAISE, LOWER, OR TRANSPORT A TRANSMISSION UNLESS IT IS SECURED
BY THE RESTRAINT SYSTEM. IT IS YOUR RESPONSIBILITY TO ADJUST THE RESTRAINT SYSTEM TO
A SUITABLE POSITION. OTC IS NOT SUBJECT TO ANY RESPONSIBILITY FOR INCORRECT SETUPS
OF THE RESTRAINT SYSTEM THAT MAY CAUSE PERSONAL INJURY AND/OR PROPERTY DAMAGE.
10. IMPORTANT: To prevent oil leakage during shipment, a shipping plug is used to ensure the best
seal. Before using the jack, remove the shipping plug and replace it with the ventilated plug.
Form No. 106458, Back of Sheet 1 of 3

Packing List

Details
Cylinder & base assembly
Legs
1/2" Allen bolts and spring washers
Casters (with 1/2" nut and spring washer)
Handle
Saddle assembly (includes base, board)
Saddle side frame
Chain
Support ear (set of 3/8" bolt, nut, & washer ea.)
Set of 1/2" bolt, nut, and washer for
corner support bracket fastening
Assembly
Tilt
Screw
Foot
Pedal
Qty.
1
2
8
4
1
1
2
2
4
4
Saddle
Caster