Publicidad
Idiomas disponibles
Idiomas disponibles
RECORDING VIA USB 2.0
FEATURES OF MULTIMIX USB 2.0 RECORDING
The MultiMix USB2.0 allows you to record every individual channel to the computer, along with the main
mix. The recorded signal is post-Gain, post-EQ and post-fader, which means that the settings you make
to these controls will affect the recorded signal.
Additionally, the balance set for the stereo channels will affect the recording. Note that, if you only plug a
source into the LEFT input of one of the stereo channels, this source will be duplicated to the right
channel.
You can record at one of four different sample rates—44.1kHz, 48kHz, 88.2kHz, and 96kHz.
A stereo return comes back from your computer to the mixer. Listen to this stereo signal by routing it
using the USB/2TK buttons in the master section.
INSTALL THE SOFTWARE ON YOUR COMPUTER
If your computer has access to the Internet, point your browser to the Support/Downloads section of
http://www.alesis.com. It's possible that updated drivers have been posted there since the time the
software DVD included with your MultiMix was manufactured.
Windows
Before attaching your mixer to your computer, install the drivers either from the website or the software
DVD. During the installation process, attach and re-attach your mixer as prompted by the install
program.
For each of the several installations that occur, click "Continue Anyway" if Windows warns you that the
drivers have not passed Microsoft Logo Certification.
Windows Logo Certification warning.
Ignore this warning by clicking "Continue Anyway."
Macintosh
Install the driver from the .dmg file.
Wait to turn on/attach your MultiMix USB2.0 mixer to your Mac until after the Mac has fully booted. If
you do not do so, your computer may not recognize the device.
You must select the "Alesis USB Audio Device" via your Mac's "Audio MIDI Setup" utility in order for
your computer to route the MultiMix USB2.0's signals into and out of your computer applications
properly.
Publicidad
