Cleaning And Care; Housing; Dirt Container; Rotary Brush - Silvercrest SABD 3.7 LI D4 Instrucciones De Uso

Cleaning and Care

DANGER! RISK OF ELECTRIC SHOCK!
► Do not clean the appliance while charging it .
Always disconnect the battery charger w
from the mains power socket before cleaning
the appliance!
NEVER immerse the appliance in water or
any other liquid!
WARNING! RISK OF INJURY!
► Ensure that the appliance is not accidentally
switched on without the dirt container 0
attached or while cleaning the rotary
brush z . Risk of injury!
ATTENTION! PROPERTY DAMAGE!
► Do not use abrasive or aggressive cleaning
materials . These may damage the surfaces .

Housing

■ Wipe off the appliance housing with a damp
cloth . If required, use a mild washing-up liquid
on the cloth .
■ Ensure that the appliance is completely dry
before reconnecting it with the battery
charger w .

Dirt container

To ensure that the performance of the cordless
sweeper does not deteriorate, empty the dirt
container 0 after every use .
■ Press the push-in connection q on the dirt
container 0 and pull it off .
■ Empty the dirt container 0 and push it back
onto the appliance so that it sits firmly on the
appliance and clicks into place on the release
knob q .
■ 36 │ GB │ MT

Rotary brush

If the rotary brush z can no longer be turned
because coarse dirt or threads have accumulated,
proceed as follows:
Remove the rotary brush z . Refer to figures E and
F on the fold-out page of these operation
instructions for further guidance:
1) Turn the cordless sweeper over and hold it so
that the rotary brush z is facing towards you .
2) Pull on the hook of the catch t and remove
the side cover r .
3) Pull the rotary brush z upwards out of the
housing and then out to the side .
4) Remove any dirt (on both sides of the brush
bristles) and clean the rotary brush z .
To do this, take a damp cloth and wipe the
individual bristle bundles from the inside to the
outside .
NOTE
► Remove hair and threads from the brush by
cutting them with the knife e and pulling
them out of the rotary brush z .
Reinsert the rotary brush z:
1) Push the round end of the rotary brush z
onto the drive shaft u .
2) Push the square end of the rotary brush z
into the housing so that the rotary brush z
sits straight in the housing again .
3) Replace the cover r in the housing .
Make sure that the catch t engages .
SABD 3.7 LI D4