Foaming Milk With Milk2Shower - melitta LATTEA Manual Del Usuario

 Foaming milk with milkshower
Prerequisite: The appliance is ready for operation.
•
Place a bowl (e. g. a latte macchiato glass) under the milk canister.
• Take off the milk canister and fill it with the milk2shower milk powder.
•
Place the milk canister on the magnetic holding point under the milk
shower (Fig. A, no. ).
•
turn the rotary switch for the milk shower clockwise to open the milk
shower.
→ the symbol for the milk shower
water flows into the milk canister and generates the milk foam. The milk foam
runs out of the milk canister into the bowl below the canister. The water flow
will stop automatically after approximately 90 ml.
•
turn the rotary switch for the milk shower anticlockwise to close the milk
shower (this can also be done prematurely if you desire less milk foam).
•
Now start the coffee dispensing process, e. g. to prepare a latte macchiato.
Heft_Lattea_EU.indd 57
is flashing. Approximately 90 ml of hot

09.07.2009 15:28:59