Front Panel - Alesis ELEVATE 5 Guia Del Usuario

Features
Rear Panel
1. RCA INPUTS – Use RCA cables (sold separately)
to connect an external sound source to these
inputs.
2. 1/4" INPUTS – Use 1/4" cables (sold separately) to
connect an external sound source to these inputs.
3. BASS BOOST – This 2-position switch allows you
to boost the speakers' bass frequencies.
4. OUTPUT TO LEFT SPEAKER – This is the audio
connection to the left speaker. Use the included
1/4" interconnection cable to connect the right
speaker to the left speaker.
5. INPUT FROM THE RIGHT SPEAKER – This is the
audio connection to the right speaker. Use the
included 1/4" interconnection cable to connect the
left speaker to the right speaker.
6. POWER ON/OFF SWITCH – Turns Elevate 5 on or off. To save energy, Elevate 5 will automatically
power off after 30 minutes of not receiving an audio signal from its inputs. Once Elevate 5 detects an
audio signal from its inputs, it will automatically power on again.
7. POWER CONNECTOR – Plug the included power cable here.

Front Panel

1. TWEETER – This
frequencies.
2. WOOFER –
frequencies.
3. HEADPHONES – Connect your 1/8"
headphones to this output to hear the mix
through your headphones. Note that while
headphones are connected to Elevate 5,
you will not be able to hear sound out of
your speakers until the headphones are
disconnected.
4. VOLUME – This knob is used to adjust the
volume of the speakers.
5. BASS PORT – The bass port augments
the bass generated by the woofer to increase the low-frequency SPL over that of non-ported speakers.
Make sure this hole is not obstructed since this will adversely affect bass response.
outputs the high
This outputs the
6
7
1
6
7
5
2
1
low
5
2
4
3
5
1
2
4
3
1
2
5 5
4
3
5
5
3
5
5
5
1
5
2
1
4
5
2
4