Installation - Metra 99-5841B Instrucciones De Instalación

It is highly advisable to read the following steps beforehand, to ensure a clear understanding of
what is to be expected. The following steps must be done in the order that they are numbered.
With the vehicle completely off:
Touchscreen display
1. Connect the 16-pin harness with stripped leads into port "B" in the touchscreen display.
2. Connect the 5841 harness to the wiring harnesses in the vehicle. These harnesses are the
ones removed in step 7 of dash disassembly. Then insert the 5841 harness into port "A" in
the touchscreen display. But do not install this harness until exactly before step 1 from the
Programming section. This is a timed process.
3. Connect the 4-pin harness with yellow RCA jacks into port "C" in the touchscreen display.
4. Disregard ports "D" and "E", they will not be used in this application.
5. Port "F" is an update port for future firmware upgrades.
A
F
Note: DO NOT CONNECT!
10
B
C
D
E

INSTALLATION

HVAC interface
6. Connect the HVAC interface harness into the HVAC interface, and then to the wiring
harnesses in the vehicle. These harnesses are the ones removed in step 5 of dash
disassembly.
Attention! Disregard the 10-pin connector from the HVAC harness, and the 4-pin flat to
4-pin stacked harness, they will not be used in this application.
7. Connect the 6-pin harness from the 5841 harness to the HVAC interface.
8. (a) For models with a 4.2-inch display screen: Connect the 12-pin backup camera harness
to the wiring harness in the vehicle. This harness is the one removed in step 6 of
dash disassembly.
(b) For models with an 8-inch display screen: Connect the female connector from the
54-pin backup camera harness to the wiring harness in the vehicle. This connector is located
behind the factory display screen, which was removed in step 6 of dash disassembly.
Note: Disregard the male connector, it will not be used in this application.
9. Locate the factory antenna connector in the dash and complete all necessary connections to
the radio. Use the antenna adapter provided to adapt the factory antenna connector to the
aftermarket radio.
|
386.257.1187 MetraOnline.com