Airwell RC08C Manual Del Usuario página 4

USIING THE REMOTE CONTROL UNIIT
HOW TO INSTALL BATTERIES
Remove the lid in the rear part of the remote control unit.
Insert two AAA alkaline batteries of 1, 5 V- DC. Make sure to insert the batteries
according to the polarity(+/-) marked in the battery compartment.
Push the lid back on.
HOW TO REMOVE BATTERIES
Remove the lid in the rear part.
Press the battery toward the negative end and lift it out by its positive end as shown.
Remove the other battery in the same way.
General Note:
Replace the batteries when the remote control unit display fails to light, when the air
conditioner does not receive the remote control unit signals or when the low battery icon
is displayed.
Remove the batteries if you do not use the remote control unit for more than one
month.
The batteries last about six months, depending on how much you use the remote
control unit.
The batteries of the remote control contain polluted substances Exhausted batteries
must be disposed according to local laws.
3
TEMPERATURE SENSOR SELECTOR
Under normal conditions the room temperature is detected and checked by the
temperature sensor placed in the air conditioner.
Press the remote control I FEEL button to activate the temperature sensor placed in
the remote control. This function is designed to provide a personalised environment
by transmitting the temperature control command from the location next to you.
Therefore, in using this function, the remote control should always be aimed,
without obstruction, at the air conditioner.
OPERATION WITH THE REMOTE CONTROL UNIT
Check that the circuit breaker on the power panel is turned ON and the STANDBY lamp
is light up.
When using the remote control unit, always point the unit transmitter head directly at the
air conditioner receiver.
HOW TO TURN ON THE AIR CONDITIONER
Press the ON/OFF button to turn the air conditioner on.
HOW TO SET THE PRESENT TIME
1. Hold down the SET button for at least 2 seconds to set present time.
The time indication alone flashes.
2. Press the + or - buttons until the present time is displayed.
3. Press the SET button to stop the indication flashing.
4
OPERATIION