Calibrating Valve Position; Configuring Your System; Menu Navigation - Akron STYLE 9323 Instrucciones De Instalación, Funcionamiento Y Mantenimiento

6.1 CALIBRATING VALVE POSITION

Menu location: Setup Menu → OEM Configuration → Valve Setup → Valve Calibration
The valve must be calibrated to ensure the position of the valve is accurate . Navigate to the Valve Calibration screen (for
details on accessing this screen and navigating the menu, see the "SETUP MENU NAVIGATION" section below) . The
screen will display the following warning: "The valve will fully open and close during calibration ." After you have verified
that the valve is properly installed to the motor, and there is no danger of damage due to water in the line, press
■ START to begin the calibration process .
The valve will fully open and close twice to calibrate the valve position sensor . After calibration is complete, press the
■ OK button to return to the Valve Setup screen .

7 CONFIGURING YOUR SYSTEM

MENU NAVIGATION

The Setup Menu provides access to all of the Navigator Pro's settings, options, and calibration procedures . The menu
options are as follows:
• Display
o Auto Dim
o LCD Brightness
o Numeric Position on Graph
• Presets
o Number of Presets
o Preset Positions
• Diagnostics
• OEM Configuration
o Valve Setup
• Valve Assignment
• Valve Name
• Valve Name
• Valve Number
• Valve Color
• Valve Calibration
• Valve Options
• Auto Open
• Use Factory Defaults
To access the Setup Menu during normal operation, press and hold the ■ MENU button for 5 seconds . The button label
will blink with the text "MENU" while the button is being held to indicate that the Setup Menu is being requested . When
the label stops blinking, release the button and the Setup Menu will be displayed . Alternatively, the
GREEN buttons can both be held down at the same time for 5 seconds and this will access the Setup Menu . NOTE:
The OEM Configuration option will only be displayed when the Setup Menu is accessed by holding the
GREEN buttons . If the ■ MENU button is used to access the menu, the OEM Configuration option will not be shown .
Throughout all of the setup and options menus, the
menu choice, or to increase or decrease a highlighted value . The three buttons below the screen will have on-screen la-
bels to identify their function . For example, pressing the ■ ENTER button will enter the highlighted menu screen . Press-
ing the ■ DONE button will return to the previous menu . These labels will change depending on which menu screen is
active .
RED and GREEN buttons can be used to move to a different
Page 09
RED and
RED and