Warning Information - Napa 791-6005 Manual De Instrucciones

WARNING INFORMATION

This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
THE NATURE OF HAZARDOUS SITUATIONS
WARNING
The use of wheel dollies is subject to certain hazards that cannot be prevented by mechanical means, but only by the exercise of
intelligence, care, and common sense. It is essential to have personnel involved in the use and operation of the dolly who are careful,
competent, trained, and qualified in the safe operation of the dolly and its proper use when working on wheel and tire assemblies.
Examples of hazards are dropping or slipping of load, caused by improperly securing loads, overloading, off-centered loads, and
improper setups.
METHODS TO AVOID HAZARDOUS SITUATIONS
WARNING
• Read, study, understand and follow all instructions before using.
• Wear eye protection that meets ANSI Z 87.1 and OSHA standards.
• Do not exceed the rated capacity.
• Use only on a hard level surface.
• Before moving the load, assure the load is centered and secured with load restraint chain.
• Apply load as close to the vertical portion of the lifting member as possible.
• Before moving, lower the load to the lowest possible point.
• No alterations or modifications shall be made to this product.
• This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Wash hands thoroughly after handling.
• Failure to heed these warnings may result in serious or fatal personal injury and/or property damage.
CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS
WARNING
Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,
MAINTENANCE INSTRUCTIONS and comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS SITUATIONS
could cause accidents resulting in serious personal injury and/or property damage.
INSPECTION AND SETUP
This is the safety alert symbol used for the INSPECTION AND SETUP section of this manual to alert you to potential
personal injury hazards. Obey all instructions to avoid possible injury.
Visual inspection should be made before each use of the hydraulic wheel dolly, checking for leaking hydraulic fluid and damaged, loose
or missing parts. Any wheel dolly which appears to be damaged in any way, found to be badly worn or operated abnormally MUST BE
REMOVED FROM SERVICE. If the wheel dolly is accidentally subjected to an abnormal load or shock, it must be inspected by a
manufacturer's authorized repair facility immediately. It is recommended that an annual inspection of the wheel dolly be made by a
manufacturer's authorized repair facility and that any defective parts, decals, or warning labels be replaced with manufacturer's specified
parts. A list of authorized repair facilities is available from the manufacturer.
Sometimes air gets trapped in the hydraulic bottle jack causing the jack ram to extend in sporadic increments instead of one smooth
extension.
PURGING AIR FROM THE MANUAL PUMP SYSTEM
a. Open the release valve by turning the release valve knob in a counterclockwise direction two full turns.
b. Pump the handle ten full strokes.
c. Close the release valve by turning the release valve knob in a clockwise direction until tight.
d. Pump the jack until the ram is extended to maximum height. If the condition remains, repeat steps "a" through "d" until air is
purged from system.
791-6005
WARNING
2
WARNING: Indicates a hazardous situation
which, if not avoided, could result in death
or serious injury.
10/18/11