Toshiba Carrier RAS-09EKV Serie Manual Del Usario página 4

9 COOLING / HEATING / FAN ONLY OPERATION
MODE
1. Press : Select Cool
2. Press : Set the desired temperature.
TEMP
Cooling: Min. 62°F (17°C), Heating: Max. 86°F (30°C),
Fan Only: No temperature indication
FAN
3. Press : Select AUTO, LOW , LOW+
MED+ , or HIGH
10 DRY OPERATION
For dehumidifi cation, a moderate cooling performance is controlled
automatically.
MODE
1. Press : Select Dry
2. Press : Set the desired temperature.
TEMP
11 Hi-POWER OPERATION
To automatically control room temperature and airfl ow for faster cooling or
heating operation (except in DRY and FAN ONLY mode)
Hi-POWER
Press : Start and stop the operation.
12 ECO OPERATION
To automatically control room to save energy (except in DRY and FAN ONLY mode)
ECO
Press : Start and stop the operation.
Note: For cooling operation, the set temperature will increase automatically
2°F (1°C)/hour for 2 hours (maximum 4°F (2°C) increase). For heating
operation the set temperature will decrease.
13 TEMPORARY OPERATION
In case the remote control has been misplaced or
discharged:
• By pressing the RESET button, the unit starts or
stops without using the remote control.
• Operation mode is set to AUTOMATIC. Preset
temperature is 77°F (25°C) and fan operation is
automatic speed.
14
TIMER OPERATION
Set the timer when the air conditioner is operating.
Setting the ON Timer
1
ON
Press : Set the desired
ON timer.
2
Press SET : Set the timer.
3
Press CLR : Cancel the timer.
Daily timer allows the user to set both, ON & OFF, timers. They will be
activated on a daily basis.
Setting Daily Timer
Press : Set the ON
1
ON
timer.
2 Press : Set the OFF
OFF
timer.
• When every day timer is activated, two arrows ( , ) are indicated.
Note:
• Keep the remote control In an area accessible to transmit signal to the
indoor unit; otherwise, time lag of up to 15 minutes will occur.
• Last settings will be saved for the next operation.
15
PRESET OPERATION
Set your preferred operation for future use. The settings will be memorized by
the unit for future operation (except airfl ow direction).
1. Select your preferred operation.
PRESET
2. Press and hold
The P mark displays.
PRESET
3. Press : Operate the preset operation.
1110655115-1_EN.indd 4 1110655115-1_EN.indd 4
, Heat , or Fan only .
, MED ,
.
.
Setting the OFF Timer
OFF
Press : Set the desired
OFF timer.
Press SET : Set the timer.
Press CLR : Cancel the timer.
3
Press .
SET
Press SET button during
4
the ( or ) mark fl ashing.
for 3 seconds to memorize the setting.
16 AUTO RESTART OPERATION
To automatically restart the air conditioner after a power failure (Power of the
unit must be on.):
Setting
1. Press and hold the RESET button on the indoor unit for 3 seconds to
cancel the operation. (3 beep sound but OPERATION lamp does not
blink)
2. Press and hold the RESET button on the indoor unit for 3 seconds to set
the operation. (3 beep sound and OPERATION lamp blinks 5 times/sec
for 5 seconds)
• Do not operate ON timer and OFF timer.
Note: Default setting of auto restart operation is on.
17 QUIET OPERATION
To operate at super low fan speed for quiet operation (except in DRY mode)
QUIET
Press : Start and stop the operation.
Note: Under certain conditions, QUIET operation may not provide adequate
cooling or heating due to low fan speed features.
COMFORT SLEEP OPERATION
18
For comfortable sleep, automatically control air fl ow and automatically turn
OFF the unit.
COMFORT
SLEEP
Press : Select 1, 3, 5 or 9 hrs for OFF timer operation.
Note: For cooling operation, the set temperature will increase automatically
2°F (1°C)/hour for 2 hours (maximum 4°F (2°C) increase). For heating
operation, the set temperature will decrease.
19 SLEEP TIMER OPERATION
To start the sleep timer (OFF timer) operation
Press SLEEP : Select 1, 3, 5 or 9 hrs for OFF timer operation.
20 MAINTENANCE
Firstly, turn off the circuit breaker.
Filter Reset
FILTER lamp lights on; the fi lter must be cleaned.
To turn off the lamp, push the RESET button on the indoor unit or the FILTER
button on the remote control.
Indoor Unit and Remote Control
• Clean the indoor unit and the remote control with a wet cloth when
needed.
• Do not use benzine, thinner, polishing powder or chemically-treated
duster.
SELF CLEANING OPERATION
21
(COOL AND DRY OPERATION ONLY)
To protect against odors caused by humidity in the indoor unit:
1. If the button is pressed once during "Cool" or "Dry" mode, the fan will
continue to run for other 30 minutes, it will then turn off automatically.
This will reduce the moisture in the indoor unit.
2. To stop the unit immediately, press the
seconds.
22 TROUBLESHOOTING (CHECK POINT)
The unit does not operate. Cooling or Heating is abnormally low.
• The power main switch is • The fi lters are blocked with dust.
turned off. • The temperature has been set
• The circuit breaker is tripped. improperly.
• ON timer is set. • Windows or doors are open.
• The air inlet or outlet of the outdoor
unit is blocked.
• The fan speed is too low.
• The operation mode is FAN or DRY.
2 more times within 30
18/11/56 10:01 18/11/56 10:01