Managing Your Alarm System; Important - Smanos W020 Manual Del Usuario

EN

Managing Your Alarm System

Power on
Connect the control panel with a power socket.
Note: The control panel will be disconnected with network if only powered
by batteries.
Network setup
It enters into the network setup interface. There are two ways to
connect the control panel with Wi-Fi:

Important:

W020 does not support WiFi of 5GHz band, If dual-
band(5GHz and2.4GHz) router is used, make sure to connect with
the 2.4GHz WiFi instead of the 5GHz's.
Option 1� One-click setup
1. Click the network configuration button (refer to page 5) on the
control panel once, you'll hear a beep from the control panel.
then the red and blue status indicators blink alternately.
11
2. Input the Wi-Fi's password on the App, then tap [Start],
when the indicator stops blinking but keeps on instead, the
configuration is successful.
Option 2. Manual configuration
1. Hold the network configuration button on the control panel
until the control panel beeps once, then the red and blue status
indicators blink alternately, means the control panel has entered
into a manual configuration state.
2. Find and choose the Wi-Fi named
list.
3. Choose manual configuration in the one-click setup interface of
W020 App.
4. Input the local Wi-Fi name and its password, click [Start].
When the status LED indicator stops blinking but keeps on instead,
it means the configuration is successful.
Note: One control panel can be controlled by multi users.
Remote control your alarm system
Network Reconnection
Arm
Pull-down to Refresh
W020 in your phone's Wi-Fi
Disarm
Home Arm
12
EN