English
Contents
English
Introduction ......................................................... 7
preparations ........................................................ 8
Operation ............................................................ 9
Maintenance...................................................... 10
Spare parts........................................................ 13
Preface
This manual describes the use of the heaters as
mentioned on the cover. The information in this
manual is important for the correct and safe use
of the heater.
Identification of the product (Fig. 1)
The identification plate is attached to the side of
the heater. The identification plate shows the
following data:
A
Type of machine
B
Production code
C
Type of fuel
D
Air output
E
Net capacity (Hi)
F
Voltage / frequency
G
Current
H
Fuel consumption
I
Year of manufacture
J
Serial number
Service and technical support
For information about the heater, please contact
your dealer or the manufacturer. Make sure you
have the type and serial number of the heater.
Guarantee and liability
For the Guarantee and Liability see the terms and
conditions.
Environment
Note
The heater is made of various metals
and synthetic materials. The heater also
contains electronic parts, which must be
treated as electronic waste. Please
contact your dealer for further
information.
6
1
1.1
1.2
A
Hoisting instruction
1.3
A
Technical data
B
Warning
C
Warning
D
Warning
1.4
The heater is designed for use at construction
sites, showrooms, sports halls, transit sheds,
workshops, preparation areas, storage areas,
greenhouses, polyurethane tunnels, spray booth
heating and to dry agriculture products and bulbs.
40.020.940 - rev. 04 - 2011
SAFETY INSTRUCTIONS
Icons used in the manual
Caution
Points to risk of damage to the
equipment.
Warning
Points to a dangerous situation, which
may result in death or serious injury.
Warning
Always switch off the power supply
before carrying out any maintenance of
repair work to the convector heater!
Hot
Some surfaces may be hot! Wait until
these parts have cooled down before
carrying out any maintenance.
Suggestions and tips to facilitate the
necessary tasks or actions.
Icons on the heater (Fig. 2)
Icons on the burner (Fig. 3)
Use in conformity with destination
Caution
If the heater will be installed indoors,
make sure that there is proper ventilation
in the room. Make sure the flue gas can
only flow to an outside source separate
from the room.
IMA-US