Publicidad
Idiomas disponibles
Idiomas disponibles
From the LD-AX-XSVI-MB1 or LD-AX-XSVI-MB2 harness to the aftermarket radio, connect the:
• Black wire to the ground wire.
• Yellow wire to the battery wire.
• Red wire to the ignition wire.
• Orange wire to the illumination wire. If the aftermarket radio has no illumination wire, tape
off the Orange wire.
• Blue wire to the antenna turn on wire.
• White wire to the left front positive speaker output.
• White/Black wire to the left front negative speaker output.
• Gray wire to the right front positive speaker output.
• Gray/Black wire to the right front negative speaker output.
• Green wire to the left rear positive speaker output.
• Green/Black wire to the left rear negative speaker output.
• Purple wire to the right rear positive speaker output.
• Purple/Black wire to the right rear negative speaker output.
2
CONNECTIONS
The following wires are for the aftermarket radios that have navigation built in:
• Connect the Light Green wire to the parking brake wire of the aftermarket navigation radio
(if applicable).
• Connect the Blue/Pink wire to the VSS or speed sense wire of the aftermarket navigation radio
(if applicable).
• Connect the Green/Purple wire to the reverse wire of the aftermarket navigation radio
(if applicable).
ASWC-1 pre-wired harness:
• This harness is to be used in conjunction with the optional ASWC-1 (not included) to retain
steering wheel controls. If the ASWC-1 is not being used, disregard this harness. If it will be
used, please refer to the ASWC-1 instructions for radio connections and programming.
Note: Disregard the harness that comes with the ASWC-1.
Publicidad
