Battipav Expert 400 Manual De Instrucciones página 44

GB
To place the machine in working position, proceed as follows:
MAKE SURE THAT THE MOTOR HEAD IS LOCKED IN THE LOWERED POSITION BY MEANS OF THE LOCKING LEVER LOCATED
ON THE MOTOR SIDE.
MAKE SURE THAT THE SLIDING CARRIAGE IS LOCKED BY MEANS OF THE CARRIAGE LOCKING STOPPER.
5 a) put the leg locking pins in release position
5
b) by means of the transport handles, lift the rear side (motor side) until the working position.
6
FOR CORRECT MACHINE POSITIONING, MAKE SURE THAT THE LEG UPPER HOLE MATCHES THE LEG
COUPLING HOLE, BEFORE FINALLY LOCKING IT (SEE PICTURE 6).
6
c) lock the legs one at a time.
HOLD THE MACHINE DURING THE LOCKING PHASES.
d) Repeat the operation for the opposite side;
5
IF THE LEGS ARE COMPLETELY REMOVED, PUT THEM BACK WITH THE 4 HOLES DOWNWARDS AND OUTWARDS.
7
e) Release the working table by means of the locking pin;
7
f) Move the working table backwards;
8
g) Turn the rear splash guard.
8
h) Remove the blade cover tie rod locking screw;
9
i) Turn the blade cover until moving the water on-off tap;
10
l) Lever the blade cover so that the blade cover tie rode can pass easily.
10
m) Put the blade cover tie rod in position;
11
n) Lock the blade cover tie rod with the screw provided that had been previously removed;
11
o) In case of difficulty in engaging the screw, move the blade cover slightly.
12
p) Engage the water hose on the water on-off valve and place the rear splash guard back in position;
13
q) With a 6 mm Allen wrench, secure the working table handle;
CHECKING BEFORE USE
14
• Before any cutting operation, make sure that the water level inside the tank is the same as the one indicated in the picture.
THE EXPERT MACHINE HAS BEEN DESIGNED FOR WORKING WITH WATER.
15
• Make sure that the power supply cable does not interfere with the cutting operations.
Use the cable lock lever to direct its passage.
BEFORE USING THE MACHINE, CHECK THERE IS POWER SUPPLY.
CONNECTING TO POWER SUPPLY
THE MACHINE IS TO BE CONNECTED TO THE POWER SUPPLY BY A RESIDUAL CURRENT CIRCUIT BREAKER
(RCCB) WITH THE FOLLOWING CHARACTERISTICS:
RCCB In 16 A Id 30 mA
N.B. To ensure correct functioning, periodically check the efficiency of RCCBs by pressing the push-button on the front of the device.
• Make sure that the section of the power supply cable cores has been measured according to the starting current and its length.
For cables up to 50 m long, a section of 4 mm
• Before connecting the machine to the power socket, check that the power supply voltage corresponds to that shown on the
plate on the machine.
• The machine must be connected to an effective earth wire.
In case of doubt, do not connect the machine.
For codes xxx / M 230V 1F, connect the machine to a protected line with a magnetothermic switch in curve D, specific for user
devices with high inrush current.
IN THE EVENT OF REVERSE MOTOR ROTATION, INVERT THE TWO PHASE PINS INSIDE THE POWER PLUG, AS
INDICATED BELOW: only for codes art.9XXXX / T380 and art.9XXXX / T380S1
18
• with a screwdriver with a slotted impression, press in the appropriate seat and turn the two phase pins;
• check the correct direction of rotation.
44
is enough.
2
Battipav srl