Machine Description; Recommended Use - Battipav Expert 400 Manual De Instrucciones

GB
• Rubber gloves and non-skid footwear are recommended when working outdoors. Wear protective hair covering to contain long
hair. Use safety glasses.
• Use a mask if working operations are dusty.
Don't abuse cord
• Never carry tool by cord or yank it to disconnect it from socket.
• Keep cord from heat, oil and sharp edges.
Avoid unsteady positions
• Be sure to work in a safe and balanced position.
Maintain tools with care
• Keep tools sharp and clean for better and safer performance.
• Follow all maintenance advice and instructions to replace accessories subject to wear. Inspect tool cords periodically and, if
damaged, have them repaired by an authorised expert. Check extension cords periodically and replace them if damaged. Keep
handles dry, clean and free from oil and grease.
Disconnect tools
• When not in use, before servicing, and when changing accessories subject to wear.
Remove service keys from tool
• Form the habit of checking to see that keys and adjusting wrenches are removed from tool before turning it on.
Avoid unintentional starting
• Be sure that the switch is off when plugging in the tool.
Extension cords for outdoor works
• When tool is used outdoors, use only extension cords intended for this particular use and so marked.
Stay alert
• Watch what you are doing. Use common sense. Do not operate tool when you are inattentive.
Check tool for damaged parts
• Before further use of the tool, check it and the safety devices for damages and be sure that they operate properly. Check for
functioning and binding of moving parts, breakage of parts, correct mounting, and any other conditions that may affect the
correct operation of the tool.
• Damaged safety devices or other parts should be properly repaired or replaced by an authorised Service Centre unless
otherwise indicated elsewhere in this instruction manual.
• Have defective switches replaced by an authorised Service Centre.
• Do not use tool if its switch cannot be turned on or off.
Warning
• For your personal safety use only accessories recommended in this instruction manual or in the relevant catalogues The use
of any other accessory or attachment other than those recommended in this instruction manual or in the relevant catalogue
may present a risk of personal injury.
Have tools repaired by qualified personnel
• This electric appliance is in accordance with the safety rules in force. Only qualified experts may carry out repairing of electric
appliances otherwise it may cause considerable danger for the user.
*
1
The noise level emitted by the machine was measured in accordance with the UNI EN12418, EN3744 standards. Measurements
were performed in the absence of load and at maximum speed using a cutting tool with a diameter of 600mm.
*
2
The machine in working conditions has a noise emission higher than 85 dB (A).
The vibration level transmitted to the hand-arm system was measured in accordance with the UNI EN ISO 5349-1 standard

MACHINE DESCRIPTION

The EXPERT site cutter is a machine intended specifically for cutting bricks, natural stone, granite, concrete items and similar
materials, up to a thickness of 285 mm. The machine uses a wet diamond tipped tool cutting system and is intended for personnel
specialized in the construction sector. The operator works in front of the moving worktop, within reach of the operating controls,
and positions the material to be cut on the moving worktop. He/she moves the moving worktop forwards to bring the material
into contact with the tool.

RECOMMENDED USE

CUTTING TOOL DIAMOND BLADE WET CUTTING
LASER/SECTORS: cement, natural stones, granite, abrasive materials (With narrow slots, max 5 mm).
THE TOOL / MATERIAL TO BE CUT MATCHES ARE PURELY INDICATIVE. ALWAYS FOLLOW THE INTENDED USE INDICATIONS
PROVIDED BY THE CUTTING TOOL MANUFACTURER BEFORE ANY APPLICATION.
Admissible working conditions: INTERMITTENT - S6 SERVICE 40%
42
40%
60%
Under load running
Repose
Battipav srl