Residual Risk - Battipav Ego 80 Manual De Instrucciones

GB
EMPTY THE TANK ONCE THE CUTTING OPERATIONS HAVE BEEN COMPLETED.

RESIDUAL RISK

During the design phase, BATTIPAV SRL paid particular attention to the aspects that may generate risks for the safety and health
of operators. In spite of this, there are still some potential risks, which are described below:
Danger of presence of electric current:
The machine has an internal electric system. CONNECT THE MACHINE TO A SYSTEM WITH DIFFERENTIAL
PROTECTION AND EFFECTIVE EARTH WIRE.
Danger of prolonged exposure to noise:
The continuative use of the machine causes an exposure to noise levels above 85 dB (A).
OPERATORS MUST USE PROPER EAR DEFENDERS.
Danger of accidental contact with the moving tool.
OPERATORS MUST WEAR HEAVY PROTECTIVE GLOVES
Danger of exposure to fragments of materials.
OPERATORS MUST WEAR PROTECTIVE GOGGLES.
ALWAYS STAY IN THE WORKING POSITION (Pos. 1 picture 13) DURING THE MACHINE OPERATION PHASES:
• During material loading;
• During material cutting;
• During the cutting tool deceleration following the machine stop.
MAINTENANCE
BEFORE PERFORMING ANY OPERATION OR ADJUSTMENT, DISCONNECT THE MACHINE FROM THE SUPPLY
MAINS.
CLEANING
DO NOT WASH THE MACHINE WITH HIGH PRESSURE WATER JETS
Through the tap located on the bottom of the recovery tank, remove any working residual from the machine.
27 28 Clean the sprayer regularly as indicated.
Clean the slide guides regularly to remove cutting residues.
29
EGO PLUS MOTOR HEAD INCLINATION ADJUSTMENT
The cutting head unit is equipped with a fixed adjusting of the 90° cut and the 45° cut.
In case of incorrect angles over time, proceed as follows:
1) loosen the tightening nut of the fixed positions with a 13 mm metric wrench.
32
2) with a 6 mm male hex wrench adjust fixed positions.
3) lock the fixed position adjustment again with the tightening nut.
FOR A CORRECT ADJUSTMENT OF THE FIXED POSITIONS, HELP YOURSELF WITH A 45° ANGLE.
SLIDING CARRIAGE ADJUSTMENT
The sliding carriage is provided with a register for adjustment.
If any excessive vertical movement of the carriage should take place, act as follows:
30
1) with a 13 mm wrench and a 6 mm Allen wrench, loosen the lower wheel supports.
42
Battipav srl