Residual Risk - Battipav Class Manual De Instrucciones

Battipav srl

RESIDUAL RISK

During the design phase, BATTIPAV SRL paid particular attention to the aspects that may generate risks for the safety and health
of operators. In spite of this, there are still some potential risks, which are described below:
Danger of presence of electric current:
The machine has an internal electric system. CONNECT THE MACHINE TO A SYSTEM WITH DIFFERENTIAL
PROTECTION AND EFFECTIVE EARTH WIRE.
Danger of prolonged exposure to noise:
The continuative use of the machine causes an exposure to noise levels above 85 dB (A).
OPERATORS MUST USE PROPER EAR DEFENDERS.
Danger of accidental contact with the moving tool.
OPERATORS MUST WEAR HEAVY PROTECTIVE GLOVES
Danger of exposure to fragments of materials.
OPERATORS MUST WEAR PROTECTIVE GOGGLES.
ALWAYS STAY IN THE WORKING POSITION (Pos. 1 picture 17) DURING THE MACHINE OPERATION PHASES:
• During material loading;
• During material cutting;
• During the cutting tool deceleration following the machine stop.
MAINTENANCE
BEFORE PERFORMING ANY OPERATION OR ADJUSTMENT, DISCONNECT THE MACHINE FROM THE SUPPLY
MAINS.
CLEANING
DO NOT WASH THE MACHINE WITH HIGH PRESSURE WATER JETS
24
It is extremely easy to clean the CLASS/CLASSplus machine by loosening the side knobs and dismantling the working table.
Through the tap located on the bottom of the recovery tank, remove any working residual from the machine.
25
AFTER THE TANK CLEANING OPERATIONS, PLACE THE WORKING TABLE BACK IN POSITION,
OBSERVING THE DISTANCE FROM THE LEG SUPPORT.
26 27
For a greater efficiency of the patented SPRAY SYSTEM lubrication system, clean it regularly as indicated.
MOTOR CARRIAGE ADJUSTMENT
The motor carriage is provided with a register for the vertical play adjustment. For correct adjustment, proceed as follows:
28
• with a 3 mm Allen wrench, screw both front adjustment dowels (A), until the play is eliminated.
29
• repeat the operation for both back adjustment dowels (B).
TIGHTEN THE FOUR REGISTERS EQUALLY IN ORDER TO OBTAIN SUITABLE SMOOTHNESS.
DISPOSAL
In the event of scrapping the entire machine, it must be disposed of in accordance with the methods laid
down by current legislation.
Main Casing
Submerged Pump
Electric Motor
Polyamide Steel Aluminum Copper
GB
Epoxy Resin
43