Evercraft 776-6108 Instrucciones De Operación página 2

FAILURE TO OBSERVE THESE WARNINGS COULD RE SULT IN IN JU RY.
` READ THIS INSTRUCTION MANUAL
CAREFULLY & UNDERST&
ALL INFORMATION BEFORE
OPERATING THIS TOOL.
• It is the responsibility of the owner to make sure all
personnel read this manual prior to using the device.
It is also the responsibility of the device owner to keep this
manual intact & in a convenient location for all to see &
read. If the manual or product labels are lost or not
legible, contact NAPA for replacements. If the operator is
not fluent in English, the product & safety instructions shall
be read & discussed with the operator in the operator's
native language by the purchaser/owner or his designee,
making sure that the operator comprehends its contents.
• Always operate, inspect & maintain this tool in
accordance with American National Standards Institute
Safety Code of Portable Air Tools (ANSI B186.1) &
any other applicable safety codes & regulations.
• For safety, top performance & maximum
durability of parts, operate this tool at
90 psig; 6.2 bar max air pressure with 3/8"
diameter air supply hose.
• Always wear impact-resistant eye & face
protection when operating or performing
maintenance on this tool (users &
bystanders).
• High sound levels can cause permanent
hearing loss. Always use hearing protection
as recommended by your employer an OSHA
regulations while using this tool (users
& bystanders).
• Operators & maintenance personnel must be physically
able to handle the bulk, weight & power of this tool.
• Keep tool out of reach of children.
• Air powered tools can vibrate in use.
Vibration,
uncomfortable positions over extended
periods of time may be harmful to your
hands & arms. Discontinue use of tool if
discomfort, tingling feeling or pain occurs.
Seek medical advice before resuming use.
• Air under pressure can cause severe injury.
Never direct air at yourself or others. Always
turn off the air supply, drain hose of air
pressure & detach tool from air supply
before installing, removing or adjusting any
accessory on this tool, or before performing
any maintenance on this tool. Failure to do
so could result in injury. Whip hoses can
cause serious injury. Always check for
damaged, frayed or loose hoses & fittings, &
replace immediately. Do not use quick detach
couplings at tool. See instructions for correct set-up.
• Do not operate a damaged or worn tool. Do not use
quick-detach couplings at tool. See instructions for correct
set-up.
• Place tool on the work before starting the tool. Do not
point or indulge in any horseplay with this tool.
776-6108
WARNING
repetitive motions
• Slipping,
operating air tools can be a major cause of
serious injury or death. Be aware of excess
hose left on the walking or work surface.
• Keep body working stance balanced & firm.
Do not overreach when operating the tool.
• Anticipate & be alert for sudden changes in motion
during start up & operation of any power tool.
• Note direction of rotation BEFORE operating this tool
• Do not carry tool by the hose. Protect
the hose from sharp objects & heat.
• Tool shaft may continue to rotate briefly after
throttle is released. Avoid direct contact with
accessories during & after use. Gloves will
reduce the risk of cuts or burns
• Keep away from rotating end of tool. Do not
wear jewelry or loose clothing Secure
long hair. Scalping can occur if hair is
not kept away from tool & accessories. Choking
can occur if neckwear is not kept away from
tool & accessories.
• Use only impact sockets & accessories on this tool.
Do not use hand sockets & accessories.
• This tool is not insulated against electric
shock.
• This tool must not be used in explosive
atmospheres.
• Do not lubricate tools with flammable or
volatile liquids
or jet fuel.
• Do not force tool beyond its rated capacity.
• Use replacement parts & accessories recommended
by NAPA.
• Servicing & repairs should only be made by an
authorized service center.
or
• Do not use (or modify) the tool for any other purpose
than that for which it was designed without consulting
the manufacturer's authorized representative.
• Do not remove any labels. Replace damaged labels.
• Failure to heed these warnings may result in personal
injury &/or property damage.
WARNING: This product can expose
you to chemicals including nickel which
is known to the State of California to
cause cancer and birth defects or other
reproductive harm. For more information
go to www.P65Warnings.ca.gov.
2
tripping &/or falling
such as kerosene, diesel
Rev. 04/18/18
while