Baxi SILA RCT MINI Instrucciones De Instalación, Funcionamiento Y Mantenimiento página 60

ENGLISH
WATER DETECTION IN CONDENSE TRAY
If the condensation build up is unable to flow out of the drain pipe and the water rises above a predetermined level it will
be detected by the sensors in the condense tray and the red LED will flash every 3 seconds until the condense tray is
drained.
The fans will stop to prevent any further water to build up.
The LED will revert back to flashing every second after water level has dropped below predetermined level the fans will
restart.
If condition persists, investigate the cause and rectify.
HANDING
This unit is delivered configured for right hand configuration.
THERMAL BY-PASS
The thermal by-pass is manually operated by turning the remote users control to By-pass position. In By-pass mode the
supply air flow rate increases and the extract flow rate decreases lowering the thermal heat recovery through the heat
exchanger, lowering the supply air temperature.
60