Pioneer SW-10 Guía De Operaciónes página 3

TERMINOLOGY AND CONTROLS
➊ STATUS INDICATOR – The LED found on the front panel will illuminate when the subwoofer is functioning.
If the unit is in Auto mode and is not receiving a signal, the light will remain off.
➋ POWER – This switch can be set to either On, Off or Auto. If the switch is in the Off position, the subwoofer
will remain off. If the switch is in the On position, it will remain on. If the switch is set to the AUTO position,
when a signal is present the subwoofer will turn on and will automatically turn off several minutes after a
signal is no longer present.
➌ LEVEL – This knob can be adjusted to control the level of output from your subwoofer. The level chosen
should allow the subwoofer to blend its output with that of the rest of your audio system.
➍ LOW PASS – This control allows for the adjustment of the low-pass filter. Adjustments can infinitely be
made from 50 Hz to 150 Hz. This will determine the highest frequency that the subwoofer will reproduce.
➎ PHASE – This switch allows for the adjustment of the phase of the subwoofer, in relation to the speakers
used in your system, 0 or 180 degrees.
➏ LINE IN – These inputs are an RCA type LFE/stereo/mono input. If you are connecting your subwoofer to
a pre-amp/processor with a LFE or Subwoofer pre-amp output, connect a single RCA cable to the Left
input. If you are connecting your subwoofer to a stereo pre-amp or processor, such as in a stereo music
system, use stereo RCA cables and connect to both the Left and Right inputs.
www.pioneerelectronics.com
POWER LEVEL LOWPASS
(Hz)
ON
AUTO
50
OFF MIN MAX 150
SW-10
Pioneer Home Entertainment U.S.A.
Made in China / Fabriqué en Chine / Hecho en China
PIONEER and the Pioneer Logo are registered trademarks of Pioneer Corporations and are
being used by Pioneer & Onkyo U.S.A. Corporation under license.
Bash and the Bash logo are registered trademarks of Sonavox
100-120V/220-240V
~50/60Hz 2A
ENGLISH
PHASE LINE IN
LEFT
180 0
RIGHT
0 0
CAUTION:
FOR CONTINUED PROTECTION AGAINST
RISK OF FIRE, REPLACE ONLY WITH
SAME TYPE FUSE AND RATING.
ATTENTION:
UTILISER UN FUSIBLE DE RECHANGE
DE ME ME TYP E ET CA LI BR E.
3