Important Safety Instructions
WARNINGS:
WARNING: TO AVOID FIRE, SHOCK OR DEATH, TURN OFF POWER at the circuit
breaker or fuse and test that the power is off before wiring! Do not remove circuit
protective devices or any other component until power is turned off.
WARNING: TO AVOID FIRE, SHOCK OR DEATH, carefully read the charging
instructions in your vehicle's manual before charging and heed the following warnings:
• DO NOT put your fingers into the vehicle connector.
• DO NOT use this product if the flexible power cord is frayed, has broken insulation or
any other signs of damage.
• DO NOT use this product if the enclosure or the EV connector is broken, cracked,
open, or shows any other indication of damage.
• Use appropriate protection when connecting to the main power distribution cable.
For 208V 3-Phase, Wye-Connected wiring: The 208V feed is from a
y-connection power grid, and the AC charger can connect to L1 and L2, L2 and L3,
L1 and L3. Earth ground must be connected to neutral at only one point, usually at
the breaker panel. Leave the unused leg open. Do not connect it to a Neutral bar,
or to ground. Be sure the center point is Earth ground somewhere in the system.
For 240V Single Phase wiring: The two phases used must each measure
120V to ground. Earth ground must be connected to neutral at only one point,
usually at the breaker panel.
• TO REDUCE THE RISK OF FIRE, CONNECT ONLY TO A CIRCUIT PROVIDED
WITH BELOW AMPERES maximum branch circuit over-current protection in
accordance with the National Electrical Code NFPA 70
SAVE THESE INSTRUCTIONS.
CAT. NO.
CIRCUIT BREAKER RATING
EVR40-B2C
EVR30-B1C
EVR30-R2C
MAINTENANCE, MOVING AND STORAGE:
• Do not attempt to disassemble or tamper with the charger.
• Do not lift or carry the entire unit by the charging cable.
• Store the charger in the temperate range of -50° C to +90° C (-58° F to +194° F).
• Never spray water or any other liquid directly at the charger or its charging plug.
Never submerge the charging plug in liquid.
• Store the charging cable properly by looping it in the cable holder. Never leave the
charging plug on the ground.
50A
40A
40A
4
.
®