Dc Power Port - Wagan Tech 900 Amp Battery Jumper Manual De Usuario

900 Amp Battery Jumper
™
d. After the engine starts, turn off the Jumper Safety Switch.
CAUTION: Excessive engine cranking can damage vehicle starter motor. If the
engine turns, but fails to start after several attempts, other technical problems might
be involved. Discontinue cranking the engine until the other problems have been
determined and corrected.
8. When finished, stand as far away from the vehicle battery as possible and
disconnect the clamps in reverse sequence to connecting procedure:
• For negative grounded systems, first disconnect negative (black) then
positive (red) clamps.
• For positive grounded systems, first disconnect positive (red) then negative
(black) clamps.
Using the Air Compressor
WARNING: Check item to be inflated for manufacturer's recommended maximum inflation
pressure. Avoid over inflation. Most tires are properly inflated between 24-35 PSI. Some truck
and bicycle tires require 40 PSI or more.
To Inflate Tires
1. Remove valve cap from air valve stem. Note: Make sure locking thumb lever is
in up position. If necessary, use valve stem adapter.
2. Insert stem connector to valve stem. Make sure connector is pushed into valve
stem as far as possible.
3. Press down the locking thumb lever to engage.
4. Set the compressor on/off switch (located next to the pressure gauge) to "on"
position by pressing down the section of switch marked "I". Note: In the event
that the tire is completely flat, raise the vehicle using a recommended jack before
inflating the tire.
5. Monitor tire pressure on air pressure gauge. Note: It is recommended to use a
separate air gauge to check the actual inflation pressure. When desired pressure
is reached, turn off compressor, turn the locking thumb lever to up position, and
remove stem connector from valve stem. Also remove valve stem adapter
if applicable.
6. Replace valve cap on valve stem.
To Inflate Plastic Inflatable (balls, air mattresses, rubber rafts, etc.)
1. Check manufacturer's specifications on the item to be inflated for correct
inflation pressure.
2. Remove valve cap cover from valve stem.
3. Insert proper valve stem adapter into stem connector as far as possible and
turn the locking thumb lever to down position.
www.wagan.com
5
with Air Compressor by Wagan Tech User's Manual—Read before using this equipment
4. Insert the other end of the valve stem adapter into inflatable air valve stem
as far as possible.
5. Set the compressor on/off switch (located next to the pressure gauge) to "I" position.
6. Monitor air pressure on pressure gauge meter. When desired pressure is reached,
turn off compressor, turn the locking thumb lever to up position, and remove stem
connector from valve stem. Also remove valve stem adapter if applicable. Replace
valve cap on valve stem.

DC Power Port

DC Power Port (accessory socket) is located on the left side of the unit. The port can power
a DC load of up to 11 Amps. Overloading the port results in "tripping" a self-resetting circuit
breaker. Removing the overload automatically restores power to the DC Power Port.
1. Uncover the dust cover from the Power Port.
2. Insert the 12V DC accessory plug into the Power Port.
3. Set the DC socket power switch (located above the DC socket) on to the "|" position.
4. Operate the appliance as usual.
5. After use, turn the switch off, to the "O"position.
6. Disconnect the accessory plug from the power port and store the accessory.
7. Replace the power port's dust cover.
8. Recharge the jump starter as soon as convenient.
Storage
This unit may be stored in any position. Make sure the clamps and air hose are securely tucked
away in their original positions. Store in a cool, dry area. If the unit is not used for a prolonged
period of time, recharge every 2 months in the winter and every month in the summer.
Specifications
Power Supply Battery 18AH sealed lead acid
Power Supply DC Output 12-volts nominal.
Air Compressor 260 PSI
Power Supply Charging Time 38 hours for first-time charging with AC charger
34-36 hours to recharge with AC charger
12-14 hours to recharge with 12-volt DC charger
Jumper Cable Length 29.5 inches/75 cm
© 2010 Wagan Corporation
All Rights Reserved
Wagan and wagan.com are trademarks used by Wagan Corporation
6