Main Components; Assembly Components; Handle Assembly - Mountfield BC 500 Li 48 Manual De Instrucciones

3.4 MAIN COMPONENTS

The machine is composed of a series
of main components that have the
following functions (Fig.1 ):
A. Motor: drives cutting means motion via
transmission shaft and angle transmission.
B. Rod: it connects the rear hand
grip to the power unit.
C. Cutting means: the element
designed to cut the vegetation
1. Cutting line head: nylon
line cutting means.
2. 4-point blade: metal disc
cutting means (in the box).
D. Cutting means guard: it is a safety
device which prevents objects drawn
up by the cutting means from being
hurled away from the machine.
E. "MONO" front hand grip: semi-circular
shaped, it is used to handle the machine
and is equipped with a leg guard.
F. "MONO" rear hand grip: used to handle
the machine and equipped with the main
on/off/acceleration control buttons.
G. Leg guard: a safety guard that
prevents accidental contact with
the cutting means during use.
H. Harness: device made up of a
fabric belt which, placed over the
shoulders, help to support the weight
of the machine during work.
I. Connection point (of the harness): where
the harness is connected to the machine.
J. Blade protection (for machine
transport and handling): protects against
accidental contact with the cutting
means that can cause serious injuries.
K. Battery: device that supplies electric current
to the tool; its specifications and regulations
for use are described in a specific manual.
L. Battery charger
request, paragraph
recharge the battery. Two battery charger
models are available: L1 (fast battery
charge); L2 (standard battery charge).
(accessory available upon
15.2): device used to
4. ASSEMBLY
IMPORTANT The safety regulations
to follow are described in chap. 2. Strictly
comply with these indications to avoid
serious risks or dangers.
For storage and transport purposes, some
components of the machine are not installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the
assembly should be done on a flat and
stable surface, with enough space for
machine handling and its packaging,
always making use of suitable equipment.
Do not use the machine until all the
indications provided in the "ASSEMBLY"
section have been carried out.

4.1 ASSEMBLY COMPONENTS

The packaging includes assembly components.
4.1.1 Unpacking
1. Carefully open the packaging, paying
attention not to lose components.
2. Consult the documentation in the
box, including these instructions.
3. Remove all the unassembled
parts from the box.
4. Remove the machine from the box.
5. Dispose of the box and packaging in
compliance with local regulations.
Before assembling, make sure the
battery is not inserted in its housing.

4.2 HANDLE ASSEMBLY

4.2.1 Assembly of the front hand grip
1. Position the front handle (Fig.
3.A) on the rod (Fig. 3.B).
2. Assemble the leg guard (Fig. 3.C) on the
hand grip making sure it faces to the left.
3. Attach the handle to the leg guard with
screws (Fig. 3.D) and nuts (Fig. 3.E).
EN - 9