MTD 450 Serie Manual Del Operador página 8

3. Align the chute deflector in position on the discharge
opening and insert hex bolt with spacer through hinge on
chute deflector (spacers fit inside of hinges). See Figure
3-4A.
4. Place second spacer over hex bolt inside other hinge and
secure with hex lock nut. See Figure 3-4B.
5. Secure both sides of chute deflector to impeller housing
using wing knobs previously removed. See Figure 3-4C.
Chipper Chute (Model Series 450)
1. Remove the three cupped washers and hex nuts from
weld studs around the opening on the side of the impeller
housing. See Figure 3-5.
2. Align the chipper chute over the weld studs, so the slot in
the bottom of the chute is facing down. See Figure 3-6A.
8 S 3 — A
ection SSembly
B
A
C
Figure 3-4
Figure 3-5
& S -U
et p
A
Figure 3-6
3. Secure chipper chute with the three cupped washers
(cupped side against the chipper chute) and hex nuts
previously removed. See Figure 3-6B. Tighten the nuts at
this time.
Chipper Chute (Model Series 460)
1. Remove the three cupped washers and hex nuts from
weld studs around the opening on the side of the impeller
housing. See Figure 3-7A.
2. Remove the hex bolts, flat washers, and lock nuts from
the two holes on the upper end of the support brace. See
Figure 3-7B.
B
Figure 3-7
B
A