Installing / Removing Battery Pack - Black and Decker LPHT120 Manual De Instrucciones

d. If charging problems persist, take the tool, battery pack and
charger to your local service center.
4. The battery pack should be recharged when it fails to produce
sufficient power on jobs which were easily done previously. DO
NOT cONTINUe to use under these conditions. Follow the charging
procedure. You may also charge a partially used pack whenever you
desire with no adverse affect on the battery pack.
5. Foreign materials of a conductive nature such as, but not limited to,
steel wool, aluminum foil, or any buildup of metallic particles should
be kept away from charger cavities. always unplug the charger from
the power supply when there is no battery pack in the cavity. Unplug
charger before attempting to clean.
6. Do not freeze or immerse charger in water or any other liquid.
WArNING:
shock hazard. Do not allow any liquid to get
inside charger. Never attempt to open the battery pack for any
reason. If the plastic housing of the battery pack breaks or cracks,
return to a service center for recycling.

INstAllING / reMovING BAttery PACK

WArNING:
Make certain the lock-off button is engaged to
prevent switch actuation before removing or installing battery.
to INstAll BAttery PACK: Insert battery pack into tool until an
audible click is heard (figure 2).
to reMove BAttery PACK: Depress the battery release button in the
back of the battery pack and pull battery pack out of tool (figure 2).
2
transporting the Pole trimmer
always remove the battery from the tool when transporting the Pole
Trimmer. Hold pole at balance point with blades towards the rear.
storing the Pole trimmer
WArNING:
sharp moving blade. to prevent accidental
operation, insure that battery is disconnected from the handle
before performing the following operations. Failure to do this
could result in serious personal injury.
1. Disconnect battery from tool.
2. The best storage place is one that is cool and dry away from direct
sunlight and excess heat or cold.
Joining trimmer head Module to handle Module
WArNING:
sharp moving blade. to prevent accidental
operation, insure that battery is disconnected from the handle
before performing the following operations. Failure to do this
could result in serious personal injury.
Combining the handle module (A) to the trimmer head module (B)
creates a pole trimmer that is approximately 6 foot in length as shown
in figure 3.
3
9
AsseMBly