Troubleshooting - Vornado V-Flow Guia Del Propietario

Problem Possible Cause and Solution
Unit fails to
Unit is not plugged in. Plug Power Cord into electrical outlet.
power on.
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
Fuse needs to be replaced. See IMPORTANT INSTRUCTIONS for how to replace the fuse or contact Consumer Service.
Unit is not pro-
Ensure unit is set to highest setting for maximum air circulation.
ducing sufficient
amount of air.
Allow the unit to fully circulate the air throughout the room, this may take several minutes.
Ensure all air inlets and outlet grill are unobstructed.
The battery is packaged separately and may not be installed. Refer to CONTROLS - Remote Control Battery on page 9
Remote Control
for instructions.
is not working.
The battery is dead. Replace with new 3 volt CR2032 battery. Refer to CONTROLS - Remote Control Battery on page 9
for instructions.
The remote requires a line-of-sight path to allow for the signal to be received by the unit. Position the unit so the
receiver lens (located above the Vornado logo) is visible from the remote control.

Troubleshooting

English 11