Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. Place the disc
12
on the flange
with a raised center, make sure that the raised center
13
is facing the flange
10
Fig. D
13
12
11
4. Screw the threaded clamp nut
a. The ring on the threaded clamp nut
towards the disc when fitting a grinding disc (Fig. E1);
b. The ring on the threaded clamp nut
face away from the disc when fitting a cutting
disc (Fig. E2).
5. Press the spindle lock
2
it locks in position.
6. Tighten the threaded clamp nut
spanner supplied.
7. Release the spindle lock.
8. To remove the disc, loosen the flange
pin spanner.
WARNING: Do not use a damaged disc.
Fig. E1
Fig. E2
10
. When fitting a disc
.
14
10
14
onto the spindle
11
must face
14
14
must
and rotate the spindle
11
until
with the two-pin
14
14
with the two-
14
12
10
11
14
12
10
11
Fitting a Wire Cup Brush
Screw the wire cup brush directly onto the spindle without
the use of the spacer and threaded flange.
Fitting and Removing a Backing
Pad/Sanding Sheet (Fig. A, D, F)
The backing pad is available at extra cost from your local
dealer or authorized service center.
1. Remove the guard from the tool.
2. Remove the backing flange
3. Place the rubber backing pad
spindle
11
.
4. Place the sanding sheet
16
5. Screw the threaded clamp nut
6. Press the spindle lock button
11
until it locks in position.
7. Tighten the threaded clamp nut
two-pin spanner.
8. Release the spindle lock
9. To remove the rubber backing pad, loosen the threaded
clamp nut
17
wih the two-pin spanner.
Fig. F
15
11
OPERATION
WARNING: Always observe the safety instructions
and applicable regulations.
•
Ensure all materials to be ground are secured
in place.
•
Apply only a gentle pressure to the tool. Do not
exert side pressure on the disc.
•
Avoid overloading. Should the tool become hot,
let it run a few minutes under no load condition to
cool the accessory.
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
ENglish
.
10
correctly onto the
15
on the rubber backing pad.
17
onto the spindle
11
.
2
and rotate the spindle
17
with the
17
16
27
Publicidad
Tabla de contenido
