Testing The Signal Strength; Setting Up Local Networks - Samsung SIR-TS360 Manual Del Propietário

3
3
CHAPTER 3
Setting up and connecting

Testing the Signal Strength

The DIRECTV HD Receiver shall have a matrix that shows the signal strength of all
transponders per orbital position in one table. This matrix is in addition to showing the
signal strength of each active transponder individually in the system setup menu.
To start the Signal Strength test, follow these steps:
Press the MENU button on your remote control.
1
Highlight the Setup menu item, then press the SELECT button.
2
Highlight the System menu item, then press the SELECT button.
3
Highlight the Signal Strength Test Matrix item, then press
4
the SELECT button. The Signal Strength Test Matrix screen
appears. The test will begin as soon as the screen appears.
Results are displayed in a moment.
NOTE
Transponders that are inactive shall have "n/a" in place of a
signal strength number.
When you have finished the system test, you can run the test
5
again using the on-screen Test Again button, exit the Menu
system by pressing the EXIT button on your remote control,
or use the arrow keys to highlight on-screen BACK button,
then press the SELECT button to return to the System menu.

Setting up local networks

You can use your DIRECTV ® HD Receiver to receive Guide information via satellite for
local off-air and cable TV channels. To use this feature, you must connect your DIRECTV
HD Receiver to a satellite dish as described earlier in this chapter, and you must set up the
Local Networks option in the menu system.
NOTE
If you do not connect your DIRECTV ® HD Receiver to a satellite dish and subscribe to
DIRECTV ® programming, you can still add local channels to the Guide by following the instructions
in the next section.
44
3
3
CHAPTER 3
Setting up and connecting
To set up the Local Networks menu option:
Press the MENU button on your remote control.
1
Highlight Setup, and press the SELECT button.
2
Highlight Installation, and press the SELECT button.
3
Highlight Local Networks, and press the SELECT button.
4
Highlight Primary Air, and press the SELECT button.
5
Highlight the first box in the ZIP code area, then use the
6
number buttons on your remote control to enter your ZIP code.
After a while, a list of cities appears below your ZIP code.
Highlight the name of the city from which your local channels
7
are broadcast, and press the SELECT button.
Highlight the on-screen BACK button, and press the SELECT
8
button. You return to the Local Networks screen.
(Optional) If you receive off-air broadcasts from a second city, highlight Secondary Air, and
9
press the SELECT button. Repeat steps 6 - 8 for the second city.
(Optional) If you receive programming from a cable TV service, highlight Cable, and press
10
the SELECT button. Repeat steps 6 - 8 for the cable service.
When you have finished entering your local broadcast and cable TV information, press the
11
EXIT button on your remote control. The DIRECTV
and then back on). After rebooting, the DIRECTV
Guide information for your local off-air and cable TV channels.
®
HD Receiver will reboot (turn itself off
®
HD Receiver will acquire and provide
®
45