Hughes & Kettner Switchblade Head 100 Manual De Instrucciones página 15

Switchblade
Standby
The STANDBY switch breathes life into those glowing
tubes. It controls the anode voltage, not the heating.
When taking a short break from playing, please use
STANDBY rather ON/OFF so the tubes remain at
operating temperature.
If you can't wait to get to it, go ahead and play your
now. The patient reader is well advised to continue reading before
letting it rip. Particularly chapters 1 (Handling) and 6 (Programming)
are mandatory, even for seasoned players.
Standard Setup and Cable Connections
�� ���
���������
�������
���������
�������
����
SWITCHBLADE
�������
���������
�����
�������
Table of Contents
1
The Fundamentals of
Handling SWITCHBLADE
2
The SWITCHBLADE's Channels
2.1 CLEAN Channel
2.2 CRUNCH Channel
2.3 LEAD Channel
2.4 ULTRA Channel
2.5 GAIN
2.6 BASS, MID, TREBLE
2.7 PRESENCE
2.8 MASTER
3
Digital Effects
3.1 REVERB
3.2 DELAY
3.3 MOD FX
4
Master
4.1 VOLUME
4.2 STORE
4.3 ORIGINAL VALUE
4.4 FX LOOP
5
Rear Panel Connections
and Control Features
5.1 EFFECTS ON/OFF
5.2 CHANNEL SELECT
5.3 FX LOOP
5.4 MIDI
5.5 SPEAKERS
6
MIDI Control and Programming
6.1 FSM 432
6.2 Setting SWITCHBLADE's MIDI Channel
and Switching OMNI ON/OFF
6.3 Factory Settings and How to ReStore Them
6.4 Storing Settings/Programming
7
Replacing Tubes, Service
and Preventive Maintenance
8
Troubleshooting
9
Technical Specifications
15